602543
4
Zoom out
Zoom in
Previous page
1/52
Next page
1 Safety
4 Installation instructions aroTHERM 0020147164_04
1.3.7 Risk of material damage caused by
using an unsuitable tool
Use the correct tool to tighten or loosen
screw connections.
1.3.8 Avoid environmental damage
caused by escaping coolant
The heat pump contains R410A coolant.
The coolant must not be allowed to escape
into the atmosphere. R410A is a fluorinated
greenhouse gas covered by the Kyoto Pro-
tocol, with a GWP of 1725 (GWP = Global
Warming Potential). If it escapes into the at-
mosphere, its impact is 1725 times stronger
than the natural greenhouse gas CO
2
.
Before the heat pump is disposed of, the
coolant it contains must be completely
drained into a suitable vessel so that it
can then be recycled or disposed of in
accordance with the regulations.
Ensure that only officially certified com-
petent persons with appropriate protective
equipment carry out maintenance work on
the coolant circuit or access it.
Arrange for the coolant contained in the
product to be recycled or disposed of by
accredited specialists in accordance with
regulations.
Only use coolant R410A.
Only use a suitable R410A tool for the
filling, pressure measurement, vacuum
generation and discharge.
Solder the lines using shielding gas. Check
the lines for leak-tightness using nitrogen.
In the event of a repair or maintenance
work, fill the coolant circuit with liquid
coolant.
If the coolant circuit is not leak-tight, check
which component must be repaired or re-
placed.
Lower the negative pressure in the coolant
circuit to max. 10 mbar (1000 Pa).
When filling the coolant circuit, observe the
values in the "Technical data" section.
1.4 Regulations (directives, laws,
standards)
As part of the installation, commissioning and
operation of the heat pump and the DHW
storage you must take into account the cur-
rent versions of the following regulations or
standards, along with any local directives or
guidelines that may apply.
Electricity at work act.
Health and safety at work act.
Relevant Utility supplier’s regulations.
Water regulations and by-laws.
Environment agency and local council re-
quirements regarding bore holes, water
courses, or noise levels.
Gas safety installation and use regulations
concerning any associated gas fired heat
source used within the heating system.
Building regulations part “L&P” and direct-
ives concerning energy saving.
Building regulations such as G3 covering
Hygiene and L8 Legieonella.
COSHH regulations.
Other relevant bodies such as HETAS and
OFTEC.
BS7671 requirements for electrical installa-
tions.
All other national and regional relevant regu-
lations for the installation of heat pumps and
heating systems must be followed.
1.5 CE label
The CE label shows that the products comply
with the basic requirements of the applicable
directives as stated on the identification plate.
The declaration of conformity can be viewed
at the manufacturer's site.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vaillant aroTHERM VWL 155-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vaillant aroTHERM VWL 155-2 in the language / languages: English as an attachment in your email.

The manual is 3,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Vaillant aroTHERM VWL 155-2

Vaillant aroTHERM VWL 155-2 User Manual - German - 24 pages

Vaillant aroTHERM VWL 155-2 User Manual - Dutch - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info