Manual V7 videoseven CS1330 (page 3 of 16) (English, German, Dutch, French, Italian, Portuguese, Spanish)

474276

Zoom out

Zoom in

1/16

English: FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) This device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna;

• Increase the separation between the equipment and receiver;

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected;

• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not authorized by the party responsible for compliance could void the user’s authority to operate

this product.

Product Safety Instructions:

Read this guide for important safety and health information and for regulatory information.

Warning: Failure to properly set up, use, and care for this product can increase the risk of serious injury or death, or

damage to the device or devices. Read this instruction and keep all printed manuals, instruction for future references. This

Product Safety Instructions includes important information about many V7 products. Refer to sections that apply to the

feature of your device.

USB Powered Devices: Do not connect the USB power cable until all other cable connections are made.

All Devices:

Do not attempt repairs. Do not attempt to take apart, disassemble, service, or modify the hardware device or power supply.

Doing so could present risk of electronic shock or other hazard. Any evidence of any attempt to dissemble and/or modify

the device, including peeling, puncturing, or removal of any of the labels, will void the Limited

Warranty.

Do not abuse the device: Do not immerse the device to any liquid or expose to moisture. Clean only with dry cloth. Do

not use the device outside the specified operating temperature range of 5°C (41°F) to 35°C (95°F). If the device is

exposed to environment outside of its prescribed operation, turn off the device and allow

the temperature to stabilize

within the specified operating range before using the device.

Regulatory Information: Disposal of Waste Electrical and Electronic Equipment (WEEE) The Waste Electrical and Electronic

Equipment (WEEE) Directive aims to minimize the impact of electrical and electronic goods on the environment, by

increasing re-use and recycling and by reducing the amount of WEEE going to landfill. The symbol on your V7

product or its packaging signifies that this product must be disposed separately from ordinary household wastes at

its end of life. Please kindly be aware that this is your responsibility to dispose electronic equipment at recycling

centers so as to help conserve natural resources.

Each country in the European Union should have its collection centers for electrical and electronic equipment recycling. For

information about your recycling drop off area, please contact your related electrical and electronic equipment waste

management authority or the retailer where you bought the product. Authorized Representative in European Community:

Ingram Micro Pan Europe GmbH, Heisenbergbogen 3, D-85609 Dornach / Munich, Germany. (www.V7-world.com)

Adjusting sound selections

1. Select Options, then Audio Format… A menu will open.

2. Change sound quality and attributes.

Setting the snapshot file size

1. Select File, then Allocate File Space…

2. Enter the desired file size in the Capture file size box, then click OK.

Setting the frame rate, color space, compression, or output

size

1. Select Options, then Video Capture Pin. The Properties menu

will open.

2. Change features by selecting them from their drop down menu,

then click OK.

Selecting still image pixels

1. Right-click the camera icon in the lower right hand corner of the

desktop.

2. Click Still Image and select your desired image pixel setting.

Setting the maximum video length

1. Select Capture, then Set Time Limit.

2. Check the Use Time Limit box and enter a time limit (in

seconds) in the Time Limit box.

3. Click OK when finished.

Adjusting special effects and other settings

1. Select Options, then Video Capture Filters. The Properties

menu will open.

2. Select a tab, make the desired changes, then click OK when

finished.

• Special Effects: Change image effects and add fun photo

frames. To reset to no effects select Normal.

• Face Tracking:

◦ Manually zoom the camera and move the zoom to one part

of the camera view.

◦ Change the tracking speed and use a picture-in-picture to

show what part of the camera view is being used in the

display.

◦ Choose the placement of the picture-in-picture.

• Face Effect: Add fun images and effects to your face. To reset

to no effects select Normal.

• Advanced: Flip the image horizontally or vertically.

• Proc Amp: Adjust the brightness, hue, saturation, sharpness,

white balance, backlight comp, and the anti flicker. Enter a

value into the appropriate box or slide the bar on each line to

the desired value. To reset the values to default, click Default,

then click OK.

• Camera Control: Adjust the exposure. Enter a value into the

appropriate box or slide the bar along the line to the desired

value. To reset the values to default, click Default, then click OK.

Safety and Maintenance Information

• Do not touch the lens with fingers or any sharp or coarse items.

• Use a soft cotton cloth to clean the lens.

• Do not use this product in extreme hot, cold, or dusty environments.

• Avoid dropping the webcam, as it may cause it to not work correctly.

Specifications

• Video capture up to 1280x1024 pixel

• Transmission Speed: 30FPS

• Interface: USB 2.0

• Focus: Manual Focus

• Distance: 5cm /1.9in to infinity

• Cable Length: 1.5 m / 4.9 ft

• Software upgrade for up to 16-mega pixel (optional)

• Automatic white balance (AWB)

• Automatic color compensation (ACC)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of V7 videoseven CS1330 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

V7 videoseven CS1330 Manual

Product: