503581

V-Zug DW-S9 Manual

16
Zoom out
Zoom in
Previous page
1/32
Next page
hood is to be xed.
• Fixing the decorative telescopic flue:
-Arrange the electrical power supply within the dimensions
of the decorative ue. If your appliance is to be installed inthe
ducting version orin the version with externalmotor, prepare
the air exhaust opening.
-Adjust the width of the support bracket of the upper ue
(Fig.3).
-Then x it to the ceiling using the screws A (Fig.3) in such a
waythat itisin line withyourhoodandrespectingthe distance
from the ceiling indicated in Fig.2.
-Connect the ange Cto the air exhaust hole using a connec-
tion pipe (Fig.4).
-Insert the upper ue into the lower ue.
-Fix the lower ue to the hood using the screws B provided
(Fig.4), extract the upper ue up to the bracket and x it with
the screws B (Fig.3).
-To transform the hood from a ducting version into a ltering
version, ask your dealer for the charcoal lters and follow the
installation instructions.
• Filter hood:
Please note:
In order to transform the hood from EXTRACTOR HOOD
into FILTER HOOD the carbon lters must be ordered at your
distributor as accessory.
-To replace the extractable active carbon filters X, pull lever
outwards as shown in Fig.6.
-Therearetwo typesofcharcoallters: regenerable (washable)
(Fig.7) and non-regenerable (Fig.6).
USE AND MAINTENANCE
• We recommend that the cooker hood is switched on before
any food is cooked.We also recommend that the appliance is
left running for 15 minutes after the food is cooked, in order
to thoroughly eliminate all contaminated air.
The eective performance of the cooker hood depends on
constant maintenance; the anti-grease lter and the active
carbon lter both require special attention.
• The anti-grease filter is responsible retaining the grease
particles suspended in the air, therefore it is subject to
clogging with variable frequency according to the use of the
appliance.
- To prevent the danger of possible res, at least every 2
months one must wash the anti-grease lters by hand using
non-abrasive neutral liquid detergents or in the dishwasher
at low temperatures and on short cycles.
- After a few washes, colour alterations may occur. This does
not give the right to claim their replacement.
• The active carbon filters are used to purify the air that is
sent back into the room and its function s to mitigate the
unpleasant odours produced by cooking.
- The non-regenerable active carbon lters must be replaced
at least every 4 months. The saturation of the active charcoal
depends on the more or less prolonged use of the appliance,
on the type of kitchen and on the frequency with which anti-
grease lter is cleaned.
- Regenerable active charcoalltersmust bewashed by hand,
with non abrasive neutral detergents, or in the dishwasher at
a maximum temperature of 65°C (the washing cycle must be
complete without dishware). Remove excess water without
damaging the lter, remove the plastic parts, and let the mat
dry in the oven for at least 15 minutes approximately at a
maximum temperature of 100°C. To keep the regenerable
charcoal lter functioning ecient this operation must be
repeated every 2 months. These must be replaced at least
every 3 years or when the mat is damaged.
• Before remounting the anti-grease filters and the rege-
nerableactive charcoal lters itis important that they are
completely dry.
• Clean the hood frequently, both internally and externally,
using a cloth dampened with denatured alcohol or neutral
liquid detergents that are non abrasive.
• The lighting .system is designed for use during cooking
and not for the prolonged general lighting of the room. The
prolonged use of the lighting system signicantly decreases
the average duration of the bulbs.
• Attention: The non compliance with the hood cleaning
warnings and with the replacement andcleaning of the lters
entailsrisk ofres. One therefore recommends keeping tothe
suggested instructions.
• Replacing halogen light bulbs (Fig.8):
To replace the halogen light bulbs B, remove the glass panel
C using a lever action on the relevant cracks.
Replace the bulbs with new ones of the same type.
Caution: Do not touch the light bulb with bare hands.
• Commands (Fig.9):
The key symbols are explained below:
A = LIGHT
B = OFF
C = SPEED I
D= SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes (*)
• If your appliance does not have the INTENSIVE speed
function, press key E for two seconds and it will be activated
for 10 minutes after which it will return to the previously set
speed.
When the function is active the LED ashes. To interrupt it
before the 10 minutes have expired press key E again.
• Clean Air:
By pressing key F for two seconds (with the hood switched
o) the “clean air” function is activated.
This function switches the appliance onfor tenminutes every
hour at the rst speed.
As soon as this function isactivated themotor starts upat the
rst speed for ten minutes.
During this time key F and key C must ash at the same time.
After ten minutes the motor switches o and the LED of key
F remains switchedon with axed light until the motor starts
up again at the rst speed after fty minutes and keys F and
C start to ash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the
hood will return immediately to its normal functioning (e.g.
if key D is pressed the “clean air” function is deactivated and
the motor moves to the 2nd speed straight away.
By pressing key B the function is deactivated).
(*) The “AUTOMATIC STOP TIMER” delays stopping of the
hood, which will continue functioning for 15 minutes at the
operating speed set at the time this function is activated.
• Anti-grease and active c arbon filters saturation:
-After 30 hours of work, the key A ashes every 2 sec.; in that
event,the anti-greaseandactivecarbon ltermustbe cleaned,
if present.
-After 120 hours of work, the key A ashes every 0.5 sec.; in
- 16 -
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for V-Zug DW-S9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of V-Zug DW-S9 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info