en
23
The dishwasher must be connected
correctly, otherwise it will not function
properly. The specifications for the inlet
and outlet as well as the electrical
connected loads must correspond with the
required criteria as specified in the
following paragraphs or in the installation
instructions.
Install the appliance in the correct
sequence:
– Checking appliance on delivery
– Installing the appliance
– Waste water connection
– Fresh water connection
– Electrical connection
Safety instructions
– Install and connect the appliance
according to the installation and
assembly instructions.
– Prior to installation, disconnect the
dishwasher from the power supply.
– Ensure that the protective conductor
system of the domestic supply has
been correctly installed.
– The electrical connection conditions
must correspond with the
specifications on the dishwasher rating
plate 9:.
– If the power cord of this appliance is
damaged, it must be replaced with a
particular power cord.
To prevent injury, the power cord may
be replaced by customer service only.
– If the dishwasher is installed in a high-
sided unit, the unit must be secured
properly.
– Install built-under or integratable
appliances only under continuous
worktops which have been screwed to
adjacent cupboards to ensure stability.
– Do not install the appliance near heat
sources (radiators, heat storage tanks,
cookers or other appliances which
generate heat) and do not install under
a hob.
– After installing the appliance, ensure
that the plug is easily accessible.
–Some models:
The plastic housing on the water
connection contains an electric valve,
the connecting cables are in the supply
hose. Do not cut through this hose, do
not immerse the plastic housing in
water.
ã=Warning
If the appliance is not in a cavity and a
side panel is accessible, the door hinge
area must be covered at the side for
reasons of safety (risk of injury). The
covers are available as optional
accessories from customer service or
specialist outlets.
Delivery
Your dishwasher has been checked
thoroughly in the factory to ensure that it is
in working order. This may cause small
water stains. These will disappear after the
first wash cycle.
Technical specifications
Weight:
max. 53 kg
Voltage:
230 V, 50 Hz
Connected load:
2,3 kW
Fuse:
10/13 A
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1MPa (10bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature
60 °C.
Installation
