Manual UTStarcom TXT8010 (page 40 of 45) (English)

596882

Zoom out

Zoom in

1/45

SAFETY INFORMATION FOR FCC RF EXPOSURE

WARNING! Read this Information before Using

Cautions

In August 1996 the Federal Communications Commission (FCC) of the United

States with its action in Report and Order FCC 96-326 adopted an updated

safety standard for human exposure to radio frequency electromagnetic

energy emitted by FCC regulated transmitters. Those guidelines are consistent

with the safety standard previously set by both U.S. and international stan-

dards bodies. The design of this phone complies with the FCC guidelines and

these international standards.

Body-Worn operation

This device was tested for typical body-worn operations with the back of

the phone kept 2.2 cm. from the body with a beltclip that contains metallic

components. To maintain compliance with FCC RF exposure requirements,

use only belt-clips, holsters or similar accessories with which this device

was tested.

The use of accessories that do not satisfy these requirements may not comply

with FCC RF exposure requirements, and should be avoided.

For more information about RF exposure, please visit the FCC website at

www.fcc.gov.

SAR INFORMATION

This model phone meets the government’s requirements for exposure

to radiowaves.

Your wireless phone is a radio transmitter and receiver. It is designed and

manufactured not to exceed the emission limits for exposure to radiofrequen-

cy (RF) energy set by the Federal Communications Commission of the U.S.

Government. These limits are part of comprehensive guidelines and establish

permitted levels of RF energy for the general population. The guidelines are

based on standards that were developed by independent scientific organiza-

tions through periodic and thorough evaluation of scientific studies. The

standards include a substantial safety margin designed to assure the safety of

all persons, regardless of age and health.

The exposure standard for wireless mobile phones employs a unit of measure-

ment known as the Specific Absorption Rate, or SAR. The SAR limit set by the

FCC is 1.6 W/kg. * Tests for SAR are conducted with the phone transmitting at

its highest certified power level in all tested frequency bands. Although the

SAR is determined at the highest certified power level, the actual SAR level

of the phone while operating can be well below the maximum value. This is

because the phone is designed to operate at multiple power levels so as to use

only the power required to reach the network. In general, the closer you are

to a wireless base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested

and certified to the FCC that it does not exceed the limit established by the

government adopted requirement for safe exposure. The tests are performed

in positions and locations (e.g., at the ear and worn on the body) as required

by the FCC for each model.

The highest SAR value for this model phone when tested for use at the ear is

1.19 W/kg PCS Head SAR and when worn on the body, as described in this user

guide, is 0.694 W/kg PCS Body SAR. (Body-worn measurements differ among

phone models, depending upon available accessories and FCC requirements).

While there may be differences between the SAR levels of various phones

and at various positions, they all meet the government requirement for

safe exposure.

The FCC has granted an Equipment Authorization for this model phone with

all reported SAR levels evaluated as in compliance with the FCC RF exposure

guidelines. SAR information on this model phone is on file with the FCC and

can be found under the Display Grant section of http://www.fcc.gov/oet/fccid

after searching on PP4ELVIS.

Additional information on Specific Absorption Rates (SAR) can be found on

the Cellular Telecommunications & Internet Association (CTIA) web-site at

http://www.ctia.org/.

* In the United States and Canada, the SAR limit for mobile phones used by

the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The stan-

dard incorporates a substantial margin of safety to give additional protection

for the public and to account for any variations in measurements.

FDA CONSUMER UPDATE

U.S. Food and Drug Administration Cell Phone Facts Consumer

Information on Wireless Phones

1. What kinds of phones are the subject of this update?

The term “wireless phone” refers here to handheld wireless phones with

built-in antennas, often called “cell,” “mobile,” or “PCS” phones. These types

of wireless phones can expose the user to measurable radiofrequency energy

(RF) because of the short distance between the phone and the user’s head.

These RF exposures are limited by Federal Communications Commission safety

guidelines that were developed with the advice of FDA and other federal

health and safety agencies. When the phone is located at greater distances

from the user, the exposure to RF is drastically lower because a person’s RF

exposure decreases rapidly with increasing distance from the source. The so-

called “cordless phones,” which have a base unit connected to the telephone

wiring in a house, typically operate at far lower power levels, and thus pro-

duce RF exposures well within the FCC’s compliance limits.

2. Do wireless phones pose a health hazard?

The available scientific evidence does not show that any health problems are

associated with using wireless phones. There is no proof, however, that wire-

less phones are absolutely safe. Wireless phones emit low levels of radiofre-

quency energy (RF) in the microwave range while being used. They also emit

very low levels of RF when in the standby mode. Whereas high levels of RF

76 Appendix Appendix 77

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of UTStarcom TXT8010 in the language / languages: English as an attachment in your email.

The manual is 2,25 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

UTStarcom TXT8010 Manual

Product: