557953
13
Zoom out
Zoom in
Previous page
1/34
Next page
13
SYNCHRONISATION
Automatic Learning Function
1. After batteries have been inserted into the temperature/humidity sensor,
wind gauge, rain gauge and receiver, the learning function will automatically
begin and runs for approximately 3 minutes.
2. Within these 3 minutes, the receiver will begin to read the temperature &
humidity signals and displays the readings.
Manual-Learning (Searching for Remote Signals)
If a new remote sensor is added, or if the signal is lost (WT440H is blinking),
the learning function must be completed again.
1. Press and hold CHN on the receiver (Diagram A [4]) for 3 seconds.
2. A beep sound indicates that the learning function has started.
3. The ‘OUTSIDE’ symbol will flash, and the unit will beep as each remote sensor
is detected.
4. Temperature & humidity readings of the remote sensor, wind direction, wind
speed and rainfall readings will be displayed on the receiver.
Note: The Auto/Manual Learn Function will not operate while the radio controlled
clock is receiving signals. (LCD radio antenna will be flashing)
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for UPM WS2635 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of UPM WS2635 in the language / languages: English as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info