581336
5
Zoom out
Zoom in
Previous page
1/8
Next page
7
8
Press the tabs to open
the thermostat.
20
21
Back-Cover
Wall
Through Hole
Wires
Wall
AM
SET
SET
HE AT
AM
SET
HE AT
AM
Wires
++
++
+ +
++
++
Back-Cover
Te r min a l s
Heating Program
! Slide the system switch to the HEAT position and press the PROGRAM key once, the P1 and
SET symbols will appear on the display. MO to FR symbol is shown indicating Weekday program
is being displayed. (Figure 3)
! Use AHEAD or BACK to select the desired start time for weekday program 1.
! Use UP or DOWN (on extreme right) to set the desired temperature.
! Temperature can be set in increments of 0.5°.
! Program time can be set in increments of 10 minutes.
! After setting correct time and temperature for program 1, press PROGRAM again to display
weekday program 2. Use same method to set the desired time and temperature for program 2.
! Repeat the procedures for weekday program 3 and 4, and weekend programs 1-4. (Figure 4)
! After complete setting of all 8 programs, press PROGRAM to return to normal display (SET
symbol will disappear). Leaving the thermostat without any keys pressed for 16 seconds while
setting will also return the display to normal.
Note:
! The PROGRAM key can also be used anytime to review all the set programs.
! To terminate the programming sequence at anytime, press DISPLAY key.
Mounting The Thermostat Back-Cover
! The back-cover should be mounted horizontally
with the terminals on the left side.
! Thread the existing wiring through the big center
hole from the back and set the back-cover
horizontally on the wall.
! Select two appropriate mounting holes and mark
the locations with a pencil. If necessary, use a level
to make sure the thermostat is leveled.
! Remove the back-cover from the wall and drill two
3/16 inch holes in the marked screw positions.
Insert the wall-anchors into the holes completely. If
necessary, use a hammer to tap-in lightly.
! Mount the back-cover with the two screws to the
wall. Make sure the metal terminals are on the left
side.
Connecting The Wires To The Terminals
Tip: Press and hold the AHEAD/BACK or UP/DOWN key to move the numbers quickly.
Figure 3
Weekday
Hour/Minute Setting
Temperature
Temperature
Program 1
Figure 4
Weekend
Hour/Minute Setting
Program 1
Figure 2
SET
Figure 1
LEVEL
+
+
+
+
+
+
+
+
+
+
Mark the locations
with a pencil
Back-Cover
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for UPM THM301M at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of UPM THM301M in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of UPM THM301M

UPM THM301M User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info