647892
51
Zoom out
Zoom in
Previous page
1/63
Next page
Restoring Default Tracking
Your scanner is set to monitor Type II systems as its default. However, if you select a preset fleet
map or program your own fleet map, then you’ll change the default setting. To reset the Type II
default for a trunking bank, follow these steps:
1. Select the Trunking Programming mode
and the bank you want to change.
2. Press
d
.
3. Use
h
or
i
to choose
E2
.
4. Press
e
.
The scanner exits the Trunking
Programming mode, acquires the data
channel, and begins searching.
Note: Your scanner saves the setting for the preset map you selected or the Type I fleet map you
programmed. If you decide to select
E1
for the bank again, the last settings used will
display.
Programming a Hybrid System
A Hybrid system is simply a Type I system with some blocks designated as Type II blocks. To
program a Hybrid system, follow the steps listed in Programming a Fleet Map in the previous
section. However, if you want a block to be Type II, select Size Code S-0.
When you begin searching a trunking bank with a Hybrid Fleet Map, you will see both types of
system IDs. That is, Type II IDs usually appear as an even number without a dash; Type I IDs
appear as a three or four digit number, followed by a hyphen, followed by a one or two digit number.
See page 58 for more information.
51
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Uniden UBC895XLT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Uniden UBC895XLT in the language / languages: English as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info