647892

Uniden UBC895XLT Manual

48
Zoom out
Zoom in
Previous page
1/63
Next page
Fleet Map Programming
If you have programmed a trunk tracking bank and select
S
, you will see user IDs display on
your screen. Since your scanner defaults to monitor Type II systems, most if not all IDs appear as
even numbers. However, if you notice an even mix of odd and even user IDs, for example 6477,
2560, 6481, 6144, 1167, etc., then you are probably monitoring either a Type I or Hybrid system.
See
Types of Trunking Systems
on page 38.
You may also notice that you’re missing responses when you hold on an active ID. Unlike Type II
systems, Type I/IIi systems require a Fleet Map that sets specific Fleet-Subfleet parameters. It’s
easy to select a Fleet Map for your scanner; what isn’t always easy is selecting or programming a
map that matches your particular area.
There are 16 preset Fleet Maps listed in the appendix that you can choose, and these are usually a
good place to start when setting up a Type I/IIi trunk tracking bank. If you choose a preset map and
still have difficulty following complete conversations, then you’ll have to program your own Fleet
Map.
Selecting Trunking Programming Mode
To change the system type which your scanner monitors, you must be in the Trunking Programming
mode. To select this mode, follow these steps:
If you are in Conventional Scan mode:
1. Press and hold
t
.
You’ll hear two short beeps and
BANK
and
TRUNK
will begin to flash in the
display.
2. Select the trunking bank you want to
program.
If you are in Trunking Scan mode:
1. Press
t
to return to conventional
mode if you have been monitoring a
trunking bank.
2. Press and hold
t
until you hear two
short beeps.
You’ll hear two short beeps, and
BANK
and
TRUNK
will begin to flash in the
display.
3. Select the trunking bank you want to
program.
48
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Uniden UBC895XLT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Uniden UBC895XLT in the language / languages: English as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info