Manual Uniden D1384 series (page 17 of 18) (English)

647752

Zoom out

Zoom in

1/18

English - 17

RF Exposure Informaon

This product complies with FCC radiaon

exposure limits under the following

condions:

x The base must be placed to allow a minimum

of 20 cm (8 inches) between the antenna and

all persons during normal operaon.

x The base must not be collocated or operated

in conjuncon with any other antenna or

transmier.

x The handset is designed for body-worn

operaon and meets FCC RF exposure

guidelines when used with any belt clip,

carrying case, or other accessory supplied

with this product. (All necessary accessories

are included in the package; any addional

or oponal accessories are not required

for compliance with the guidelines.) Third

party accessories (unless approved by the

manufacturer) should be avoided as these

might not comply with FCC RF exposure

guidelines.

Industry Canada (I.C.) Noce

Terminal equipment

NOTICE: This equipment meets the applicable

Industry Canada Terminal Equipment

Technical Specicaons. This is conrmed by

the registraon number. The abbreviaon

IC before the registraon number signies

that registraon was performed based on

a Declaraon of Conformity indicang that

Industry Canada technical specicaons were

met. It does not imply that Industry Canada

approved the equipment.

NOTICE: The Ringer Equivalence Number

(REN) for this terminal equipment is marked

on the equipment itself. The REN assigned

to each terminal equipment provides an

indicaon of the maximum number of

terminals allowed to be connected to a

telephone interface. The terminaon on an

interface may consist of any combinaon of

devices subject only to the requirement that

the sum of the Ringer Equivalence Numbers

of all the devices does not exceed 5.

Radio equipment

The term IC before the radio cercaon

number only signies that Industry Canada

technical specicaons were met. Operaon

is subject to the following two condions: (1)

this device may not cause interference, and

(2) this device must accept any interference,

including interference that may cause

undesired operaon of the device. "Privacy of

communicaons may not be ensured when

using this telephone."

Warranty (1 Year, Limited)

Evidence of original purchase is required

for warranty service.

WARRANTOR: UNIDEN AMERICA

CORPORATION ("Uniden")

ELEMENTS OF WARRANTY: Uniden warrants,

for one year, to the original retail owner, this

Uniden Product to be free from defects in

materials and crasmanship with only the

limitaons or exclusions set out below.

WARRANTY DURATION: This warranty to the

original user shall terminate and be of no

further eect 12 months aer the date of

original retail sale. The warranty is invalid if

the Product is (A) damaged or not maintained

as reasonable or necessary, (B) modied,

altered, or used as part of any conversion

kits, subassemblies, or any conguraons

not sold by Uniden, (C) improperly installed,

(D) serviced or repaired by someone other

than an authorized Uniden service center

for a defect or malfuncon covered by this

warranty, (E) used in any conjuncon with

equipment or parts or as part of any system

not manufactured by Uniden, or (F) installed

or programmed by anyone other than as

detailed by the owner's manual for this

product.

STATEMENT OF REMEDY: In the event

that the product does not conform to this

warranty at any me while this warranty is

in eect, warrantor will either, at its opon,

repair or replace the defecve unit and

return it to you without charge for parts,

service, or any other cost (except shipping

and handling) incurred by warrantor or

its representaves in connecon with the

performance of this warranty. Warrantor, at

its opon, may replace the unit with a new

or refurbished unit. THE LIMITED WARRANTY

SET FORTH ABOVE IS THE SOLE AND ENTIRE

WARRANTY PERTAINING TO THE PRODUCT

AND IS IN LIEU OF AND EXCLUDES ALL OTHER

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Uniden D1384 series in the language / languages: English as an attachment in your email.

The manual is 0,97 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Uniden D1384 series Manual

Product: