647706
19
Zoom out
Zoom in
Previous page
1/132
Next page
19
When battery icon flashes and the scanner beeps every 15 seconds, replace or
recharge the batteries.
The scanner has a built-in circuit that lets you recharge rechargeable batteries while
they are in the scanner.
When the scanner is turned on, the scanner will not charge the batteries.
When the scanner is turned off, the scanner will charge the batteries.
Plug the USB cable into the scanner when the scanner is off and “Battery Charge”
- “Start Charging? Yes = “E”/ No = “.” will display. Press E/yes.
The scanner displays “Normal Charging” and charges the batteries according to
the “Set Charge Time” setting.
When charging is finished “Charge Complete” will be displayed.
Note that the charge is controlled strictly by a timer. It is impossible to detect the
charge state of cells charged at the low rate the scanner uses or when cells are
charged in series.
CONNECTING THE USB CABLE
The USB jack is located under the rubber flap on the right side.
The serial mode may be used for serial control and programming the scanner when
using software from 3rd party developers.
The USB cable can also power the scanner when the batteries are removed. Plug
the USB cable into the scanner with no batteries and “No Battery” will display. Press
and hold to turn on the scanner. Press again to turn the backlight on.
TURNING ON THE SCANNER AND SETTING THE SQUELCH
Note: this applies to a fresh scanner right out of the box or one that has been
reset.
Press and hold for about 2 seconds to turn on the scanner. The scanner
should start scanning one of the preprogrammed systems after the welcome screen
disappears. If the screen is too dark, press to turn on the backlight. Press
Hold. Press the scroll control to display the volume level. Turn the scroll control
(within 10 seconds) to adjust the volume. Press the scroll control again to close the
volume level (or let it disappear after 10 seconds). Press Func then press the scroll
control to display the squelch level. Turn the scroll control counter-clockwise all the
way then clockwise until the noise stops, then one notch more. Press the scroll
control to close the squelch level.
Right away you may want to check these settings in the ‘Settings’ menu. Set
Backlight, Adjust Key Beep, and Adjust Contrast.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Uniden BCD325P2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Uniden BCD325P2 in the language / languages: English as an attachment in your email.

The manual is 4,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info