Manual Uebler X31S (page 21 of 84) (English, German, Dutch, French, Polish, Portuguese, Spanish)

807822

Zoom out

Zoom in

1/84

- 19 -

General safety instructions

The vehicle owner is responsible for ensuring that his or her field

of view and hearing are not impaired by the load or the condition

of the vehicle. It must be ensured that the vehicle and load are

in accordance with regulations and that vehicle road safety is not

impaired by the load.

The required lighting and lighting systems must also be present

and operational during the day.

These mounting and operating Instructions contain the general

approval of the bicycle rack for trailer hitches and must always

the kept in the vehicle when the rack is mounted.

Observe the legal regulations regarding use of the bicycle rack

in the country of use.

Attention

The operating steps and safety instructions described in these

mounting and operating Instructions must be adhered to.

The bicycle rack for the trailer hitch is intended only for

transporting bicycles. The bicycle rack is not suitable for

use on rough terrain.

All screw connections and attachments of the bicycle rack and

the bicycles must be tested before assembly, before every trip

and during lengthy trips to ensure they are sitting firmly, and

they must be retightened if necessary. This check must be

repeated at regular intervals regardless of road conditions.

During the trip, the driver should check the bicycle rack and

bicycles for any shifting/changes in position by glancing in the

rear view mirror.

If changes are noticed, proceed to the next possible stopping

area at reduced speed and retighten the screw connections

and attachments of the bicycle rack or bicycles.

If these instructions are not followed, the bicycle rack and/or the

load may free themselves from the vehicle and cause injury to

you and other persons, or may result in an accident.

Attention

Do not use lubricants on the pre-mounted screw connections.

This could cause the screw connections to loosen and the

bicycle rack together with the mounted bicycles may free

themselves from the vehicle; this may cause injury to you

and other persons, or may result in an accident.

Attention

If the load (the bicycles) extends more than 40 cm beyond the

outer edge of the lit area of the side-marker lights or tail lights

of the rear rack system, the load must be marked at most 40 cm

from the edge and at most 150 cm above the road surface, at

the front by a white light and at the back by a red light.

Separately mark the bicycle wheels extending out laterally

during transport.

When driving at night, cover the rear lights and reflectors of

the bicycles to prevent confusion with the rearward-

facingvehicle lighting and to avoid hindering or confusing other

road users.

Failure to do so could result in an accident

Attention

Before starting a trip, check that the lighting system is

functioning correctly. When the rear fog light on the bicycle

rack is switched on, the rear fog light of the vehicle must be

switched off, i.e they must be illuminated at the same time.

In vehicle models whose type approval was initially issued after

1 October 1998, the mounted rearrack system and the load

must not cover the third brake light of the vehicle. The third

brake light of the vehicle must be visible: on the left and right,

relative to the longitudinal vehicle axis, at a horizontal angle of

10°; at the top relative to the top edge of the lamp, at a

verticalangle of 10°; and at the bottom, relative to the lower

edge of the lamp, at a vertical angle of 5°. If these values are

not met, a “third” replacement brake light must be installed.

Failure to do so could result in an accident

Attention

The mounted bicycle rack and bicycles alter the driving and

braking characteristics as well as the lateral wind sensitivity

of the vehicle. A maximum speed of 130 km/h must not be

exceeded.

Do not cover the bicycles with tarps, protective covers or

s imilar as this greatly influences both areas exposed to the

wind and driving behaviour.

Slide any heavy cargo in the luggage compartment as far

forward as possible to avoid excessively loading down the

rear of the vehicle.

Always adjust your driving style to the road, traffic and weather

conditions and exercise special care when driving with a

loaded bicycle rack.

If these instructions are not followed, the bicycle rack and/or the

load may free themselves from the vehicle and cause injury to

you and other persons, or may result in an accident.

Attention

If the vehicle is equipped with an electrical luggage

compartment lid, allow for the necessary clearance when

mounting the bicycle rack. If possible, the electrical luggage

compartment lid should be de-activated and operated

manually.

Remove the bicycle rack before using automatic car washes.

Otherwise, the bicycle rack, the vehicle and/or the carwash

could be damaged.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Uebler X31S in the language / languages: English, German, Dutch, French, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 21.54 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Uebler X31S Manual

Product: