784053
8
Zoom out
Zoom in
Previous page
1/40
Next page
1080p Indoor/Outdoor
IP Camera with Infrared
and Optical Zoom
Model: UVC-G3-PRO
Introduction
Thank you for purchasing the Ubiquiti Networks®
UniFi® Video G3 Pro Camera. This Quick Start
Guide is designed to guide you through
installation and also includes warranty terms.
Package Contents
UVC-G3-PRO Tightening Tool
Screw Anchors
(Qty. 2)
Self-Tapping Screws
(Qty. 2)
1080p Indoor/Outdoor
IP Camera with Infrared
and Optical Zoom
Model: UVC-G3-PRO
Pole Mount
Bracket
Machine Screws
(Qty. 2)
Quick Start
Guide
Installation Requirements
Pole-mounting: Two metal straps / hose
clamps (not included)
Shielded Category 5 (or above) cabling with
drain wire should be used for all outdoor
wired Ethernet connections and should
be grounded through the AC ground of
the PoE.
We recommend that you protect
your networks from harmful outdoor
environments and destructive ESD events
with industrial-grade, shielded Ethernet
cable from Ubiquiti Networks. For more
details, visit www.ubnt.com/toughcable
Surge protection should be used for all
outdoor installations. We recommend that
you use two Ethernet Surge Protectors,
model ETH-SP, one near the camera and the
other at the entry point to the building. The
ETH-SP will absorb power surges and safely
discharge them into the ground.
To LAN
ETH-SP
ETH-SP
US-8-150W
UVC-G3-PRO
Diagram Showing Use of Ethernet Surge Protectors
TERMS OF USE: All Ethernet cabling runs must use CAT5 (or above).
Shielded Ethernet cable and earth grounding must be used for
outdoor installations as conditions of product warranty. TOUGHCable
is designed for outdoor installations. It is the professional installer’s
responsibility to follow local country regulations.
Hardware Overview
Mounting Base
Cable Gland
Tilt/Mount Ring
Adjustable Base
Camera
Ring
Camera Lens
Ambient Light Sensor
Reset Button
Ethernet Port
Microphone
Cable Slot
Ethernet 10/100 RJ45 port connects to an
802.3af/802.3at or 24V Passive PoE switch for
PoE power and data.
Reset Button To reset to factory defaults,
press and hold the Reset button for more than
10 seconds while the camera is poweredon.
Before You Begin
Remove the sticker from the bottom of the
Mounting Base.
Installation Overview
To install the camera, please follow the
instructions of the following sections in this
order:
1. Hardware Installation
2. Connecting Power over Ethernet
3. UniFi Video
4. Adjusting the Camera View
Hardware Installation
The camera can be mounted on a wall, ceiling,
or pole. Follow the appropriate steps for your
installation:
Wall/Ceiling Mount
1. Remove the Mounting Base from the
camera by turning the Tilt/Mount Ring
counterclockwise.
2. Mark the mounting holes on the wall or
ceiling.
Note: If you are running the cable along
the wall or ceiling, position the Cable
Slot towards the direction you want the
cabling to run. For outdoor installations,
position the Cable Slot downward.
3. Use a 7 mm (¼") drill bit to drill the
mounting holes in the wall or ceiling.
Note: If
you are running the Ethernet
cable through the wall, cut a hole
centered between the mounting
holes that is large enough to feed the
cable through.
4. Insert a Screw Anchor into each mounting
hole.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ubiquiti Unifi Video G3 Pro - UVC-G3-PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ubiquiti Unifi Video G3 Pro - UVC-G3-PRO in the language / languages: English as an attachment in your email.

The manual is 6.09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info