541862
4
Zoom out
Zoom in
Previous page
1/20
Next page
2
EdgeRouter
Lite Quick Start Guide
Hardware Overview
Front Panel Ports
eth0 eth1 eth2
Console
ResetEthernet (eth0-eth2)
Interface Description
Console
RJ45 serial console port for Command Line Interface
(CLI) management. Use a RJ45-to-DB9, serial console
cable, also known as a rollover cable, to connect the
Console port to your computer. (If your computer
does not have a DB9 port, then you will also need a
DB9 adapter.) Then configure the following settings
as needed:
Baud rate 115200
Data bits 8
Parity NONE
Stop bits 1
Flow control NONE
Ethernet
(eth0-eth2)
10/100/1000 Mbps Ethernet ports.
Reset
There are two methods to reset the EdgeRouter to
factory defaults:
Runtime reset (recommended) The EdgeRouter
should be running after bootup is complete. Press
and hold the Reset button for about 10seconds
until the right LED on port eth2 starts flashing
and then becomes solidly lit. After a few seconds,
the LED will turn off, and the EdgeRouter will
automatically reboot.
Power-on reset Disconnect the Power Cord from
the Power Adapter. Press and hold the Reset
button while connecting the Power Cord to the
Power Adapter. Keep holding the button until the
right LED on port eth2 starts flashing and then
stops flashing after a few seconds.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ubiquiti Edgemax - Edge Router Lite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ubiquiti Edgemax - Edge Router Lite in the language / languages: English as an attachment in your email.

The manual is 3,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info