WARNING
Precautions concerning the handling of the battery housing (head Assy) after removal.
Silicon grease has been applied to the seals on the battery housing. Sand and other debris easily stick to this.
Be careful to avoid this situation.
Water leakage is caused almost entirely by sand or other debris adhering to the seal area.
Please put the battery housing (head Assy) in a safe clean place lying down
on the ribs located on its base.
Please do not place it on sand or on rocks etc.
Charging the battery (in case of LEAD-ACID battery).
CAUTION
In this book, it explains only the LEAD-ACID battery as an example.
Please refer to the manual attached for each product when you use the NI-MH battery.
STEP1 Preparation for charging,
Please stand the scooter vertically on the propeller cover.
Make sure it's on a flat stable surface so that it cannot fall over and cause
damage to the propeller cover and blades.
If the scooter is wet, wipe all moisture off completely.
STEP2 Unfasten the locking buckles.
Unfasten four locking buckles on the body seal. A locking mechanism is
attached to the locking buckle to prevent it from releasing as a result of
unexpected shocks.
First, while pushing the square button in the center of
the locking buckle, lift the end of the buckle.
Next, after releasing the buckle hook, flip the buckle
downward. Release all four parts.
STEP3 Removing the battery housing.
It may be difficult to remove the battery housing (head Assy) due to negative pressure inside the body caused
by contact with the O-ring, temperature variation and other factors.
In this case, place the buckle latch under the locking hook and apply pressure with your thumb while pushing
upwards. Do this on both sides of the scooter concurrently to break the seal and easily release the
battery housing (head Assy).
Remove the head Assy.
If it is hard to remove head Assy • • •
PUSH
UP
Push the hook with arms.
UP
07
Arms
Hook
Preparation