Upon plugging the unit in or pushing any button, the unit will beep.
When the unit is turned off, the LCD display is off. When the POWER button is
pushed, the blue LCD display lights up and the time is displayed. After a few
seconds, the display extinguishes again and the unit enters standby mode.
Pushing the POWER button when the unit is turned on or in standby mode
will turn the air purifier off (the display is dark).
When plugging the unit in (or after an interruption in the ciruit) the display
will show 00:00.
To set the time, press the TIMER button until unit beeps (the hour display
will blink). Set the hour with the SPEED or IONIZER button. After setting the
desired hour, wait a moment until the minute display begins to blink. Use
the SPEED or IONIZER button to set the minutes. Wait until the display stops
blinking. You have successfully set the clock.
Note: The clock can only be set in Standby mode.
If the unit is not already in Standby mode (clock is displayed), press the
POWER button. Turn the unit off by pressing the POWER button again.
Turn the unit on by pressing the SPEED button. The air purifier automatically
starts on the highest setting (the fan symbol in the display runs fast).
The fan setting can be adjusted by repeatedly pressing the SPEED button
(the bar and fan display change).
Available settings: High, medium, low, and standby.
4.4. Electrical connection
4.6. Power on/off and
fan adjustment
4.5 Setting clock