615565

Tunturi Go 15 loopband Manual

9
Zoom out
Zoom in
Previous page
1/60
Next page
GB
OWNER’S MANUAL
•
GO RUN 15
9
• You can set the speed and incline of
each profile bar also manually during
training.
Maintenance
The equipment is safe to use only when
periodically maintained and inspected for
faults and wear.
CAUTION!
Do not attempt any servicing or
adjustment other than those described
in this manual. Any other servicing must
be performed by an authorized service
representative. Check the tightness of
all fixing screws once a year. Do not
overtighten.
CLEANING AND LUBRICATING THE
TREADMILL
FAILURE TO LUBRICATE YOUR
TREADMILL MAY INVALIDATE THE
PRODUCT’S WARRANTY!
Wipe the treadmill surfaces, especially
the handlebars and console from dust
with a damp cloth or towel. Do not use
solvents. Use a small vacuum nozzle
to carefully vacuum around all visible
components (belt, running deck, side
rails etc.). Also keep the area near
the treadmill clean. While in use,
the treadmill gathers dust that may
cause problems in the operation of the
equipment. In average domestic use (a
maximum of 60 minutes a day),
you should check the lubrication once
a month
However, lubricate the belt only if
needed. In more demanding use, the
lubrication needs be checked at shorter
intervals. This is best done before you
begin a training session. Check the
lubrication as follows:
• Ensure the treadmill is powered off!
Step on the treadmill belt .and stand
steadily where you normally run on
the belt.
• 2. Take hold of the horizontal
handlebar and push the belt with
your feet so that it slides back and
forth. The belt should move softly and
evenly, without a sound.
• 3. If you notice jerky movement or
if the belt will not slide check for
lubrication by sliding your hand under
the belt.
Lubricate the running deck according
to the following instructions:
• Attach the nozzle of the lubrication
tube to the T-Lube S container.
• Lift the running deck and lock it.
• Position the nozzle between the belt
and the board. Try to reach the spray
as far into the center of the running
deck as possible.
• Spray the lubricant for 2-3 seconds.
• Lower the running deck into its
normal position. Use treadmill for
your training session. Or allow the
treadmill to run for at least 5 minutes.
NOTE!
Lubricate your treadmill only with T-Lube
S silicon lubricant. Contact your local
Tunturi distributor for further supplies
of T-Lube or further information on
lubrication and maintenance.
ALIGNING THE RUNNING BELT
Monitor belt tracking during exercise and
make adjustments as needed. The belt
should run in the center of the treadmill.
Alignment is not usually needed,
provided
• The treadmill is placed on an even,
solid and horizontal surface and the
belt is correctly tensioned
• The alignment of the belt is correct
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tunturi Go 15 loopband at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tunturi Go 15 loopband in the language / languages: English, German, Dutch, French, Finnish as an attachment in your email.

The manual is 2,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info