Manual Tunturi Cardio Fit T10 - 2020 (page 14 of 68) (English, German, Dutch, French, Italian, Swedish, Spanish, Finnish)

736481

Zoom out

Zoom in

1/68

English

To start the equipment:

- Insert the mains plug into the equipment.

- Insert the mains plug into the wall socket.

- Set the master power switch to the on position.

To stop the equipment:

- Set the mains power switch to the off position.

- Remove the mains plug from the wall socket.

- Remove the mains plug from the equipment.

Safety key (Fig F-4)

The equipment is equipped with a safety key that must be properly

inserted into the slot on top of the handrail to start the equipment.

If you remove the safety key from the slot, the equipment will stop

immediately.

- Insert the safety key into the slot on top of the handrail.

- Make sure that the clip of the safety key is properly attached to

your clothing.

- Make sure that the clip is not removed from your clothing before

the safety key is removed from the handrail.

‼ NOTE

• Console will show ---- -- --- when safety key is not in (correct)

position during start up.

Circuit breaker (Fig. E-2B)

The equipment is equipped with a circuit breaker that interrupts the

circuit when the electricity load is above the maximum capacity. When

this occurs, the circuit breaker must be pressed.

⚠ WARNING

• Before pressing the circuit breaker, remove the mains plug from

the equipment.

If the equipment shuts down, proceed as follows to restart the

equipment:

- Remove the mains plug from the equipment.

- Press the circuit breaker to restart the equipment.

- Insert the mains plug into the equipment.

‼ NOTE

• Some circuit breakers used in homes are not rated for high

inrush currents that can occur when a treadmill is first turned

on or even during normal use. If your treadmill is tripping the

circuit breaker (even though it is the proper current rating and

the treadmill is the only appliance on the circuit) but the circuit

breaker on the treadmill itself does not trip, you will need

to replace the breaker with a high inrush type. This is not a

warranty defect. This is a condition we as a manufacture have no

ability to control.

Folding & Unfolding the equipment.

‼ NOTE

• Before folding or unfolding the equipment, make sure the

remote control is taken out the holder to avoid it from falling

out.

• The both clamp levers ( #8) can be pulled out, and freely

repositioned without tightening, or loosen the fixture.

Release the clamp levers ( #8) and turn to adjust the fixation.

Unfolding the equipment (fig. F1)

- A-When being in vertical storage position

- While supporting the treadmill frame, loosen stabilizer frame

fastening knob (#43) on the RH side of the stabilizer frame ( #42) by

turning it in counter-clockwise direction.

- Tilt the mainframe slightly forwards and fold in the stabilizer frame.

- While supporting the treadmill frame, fasten stabilizer frame

fastening knob (#43) on the RH side of the stabilizer frame ( #42) by

turning it in clockwise direction.

- Lower the upright positioned treadmill in the horizontal position.

- B-When being in horizontal storage position.

- Turn both clamps levers ( #8) in the counter-clockwise direction to

loosen the fixation of the handrail.

- Tilt the handrail in the upright position. ( slightly forward angle )

- Turn both clamps levers ( #8) in the clockwise direction to fixate the

fixation.

- Trainer is now in ready-to-use position.

Refer to the illustrations for the correct way of unfolding the

equipment.

Folding the equipment (fig. F2)

- A-When being ready-to-use position

- Turn both clamps levers ( #8) in the counter-clockwise direction to

loosen the fixation.

- Guide the handrail in the downwards horizontal position.

- Turn both clamps levers ( #8) in the clockwise direction to fixate the

fixation of the handrail.

- Trainer is now in horizontal storage position.

- B-When being in horizontal storage position.

- Tilt the treadmill frame in the upright position by lifting it on the

mainframe ( Do not lift the treadmill by holding the handrail ).

- While supporting the treadmill frame, loosen stabilizer frame

fastening knob (#43) on the RH side of the stabilizer frame ( #42) by

turning it in counter-clockwise direction.

- Tilt the mainframe slightly forwards and unfold in the stabilizer

frame.

- While supporting the treadmill frame, fasten stabilizer frame

fastening knob (#43) on the RH side of the stabilizer frame ( #42) by

turning it in clockwise direction.

- Treadmill is now in vertical storage position. .

Refer to the illustrations for the correct way of folding the equipment.

Console (fig. E-1)

⚠ CAUTION

• Keep the console away from direct sunlight.

• Dry the surface of the console when it is covered with drops of

sweat.

• Do not lean on the console.

• Only touch the display with the tip of your finger. Make sure that

your nails or sharp objects do not touch the display.

‼ NOTE

• The console switches to standby mode when the equipment is

not used for 10 minutes.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Tunturi Cardio Fit T10 - 2020 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 4,99 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Tunturi Cardio Fit T10 - 2020 Manual

Product: