782452
10
Zoom out
Zoom in
Previous page
1/12
Next page
10
MAINTENANCE
To maintain the machine at maximum efciency, have qualied per-
sonnel perform a maintenance check at least once a year.
Before cleaning or performing maintenance, opening or disassem-
bling the panels, switch off the device and turn off the gas supply.
Check the main burner and the pilot ame, the ignition electrode,
the safety valve and that there is no leakage. Check that there
is nothing obstructing the passages within the exchanger smoke
channel.
To clean the outside of the panels utilize a cloth with soap and
water.
Do not use solvents, powders or abrasive sponges.
Do not clean the device and/or its parts with ammable materials
(e.g. petrol, alcohol, diesel etc.).
Removing the casing
To remove the outer casing follow the steps below:
- Remove the selector Knobs (A and B)
- Remove the screws (C)
- Shift the casing upwards to free it from the upper and lateral hooks
- Shift the casing forwards
- To reinsert the casing, follow the above steps in reverse order
Troubleshooting: problems and solutions
For the best functioning of the water heater, to prolong its lifetime
and ensure that it is always safe, ensure that it is inspected at least
once a year by a trained professional. The trained professional is
to perform the following maintenance operations:
- Remove any rust from the burner
- Remove any deposit on the glow plug by the electrode
- Clean the combustion tank
- Check the ignition, switching off and general functionality of the
device
- Check that the gas and water tubes and connections are sealed
Warning: the owing repair instructions are only to be performed by
qualied and authorized technicians.
Fig. 18
PROBLEM CAUSE SOLUTIONS
Device shuts off after several minutes - No ue pipe connected, too many bends in the
ue or not enough draw
- Mount a ue pipe with Enough vertical length
There is no spark - Exhausted battery - Substitute
- Electrical cable of device is disconnected - Insert
- Electrical card is broken - Test, substitute
- There isn’t sufcient water pressure - Repair the device to guarantee pressure, rotate
the selector knob all the way to the right
- The membrane is broken - Substitute
- The electrode is damaged - Substitute
The pilot does not switch on when
there is a spark
- Safety device broken - Substitute
- No gas supply - Open the gas tap
- Air in the gas tubes - Release gas
The burner does not switch off when
the water turns off
- Grime on the gas shutter - Test, clean
- Valve piston or stem is locked in open position - Disassemble, clean and eventually substitute
- Micro lever is locked in open position - Test
- If an LPG supply, check the gas pressure - Regulate and if necessary substitute the tank
pressure regulator
The exchanger blade becomes dirty
in a small amount of time
- Poor draught or dusty surroundings - Check the smoke channel efciency
- Yellow ame - Check the gas type and clean the burner
- Excess gas consumption - Check and regulate
There is a smell of gas - Due to the loss of gas in the tubes, check the
tubes and nd the leak
- Do not activate electric switches or any object
that produces sparks in local area
There is a smell of gas - It can be caused by obstruction in the ue gas
circuit
- Check the efciency of the smoke channel and
the ue gas conduit
- Excess gas consumption - Check and regulate
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TTulpe Indoor B-11 P50 Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TTulpe Indoor B-11 P50 Eco in the language / languages: English as an attachment in your email.

The manual is 1.83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of TTulpe Indoor B-11 P50 Eco

TTulpe Indoor B-11 P50 Eco Usermanual and installation guide - German - 12 pages

TTulpe Indoor B-11 P50 Eco Usermanual and installation guide - Dutch - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info