782478
13
Zoom out
Zoom in
Previous page
1/24
Next page
13
Warnings before ignition
Please remember that appliance installation, rst ignition, maintenance and
repairs must be performed by qualied personnel.
Before turning on the appliance, proceed with suitable checks:
hEnsure the gas system seal is good (according to current regula-
tions)
hMake sure mains data match those stated on the data plate
hMake sure the installation meets current local regulations
hCheck the type of gas set for appliance operations on the serial
plate
hMake sure the ue meets current regulations
hMake sure the system pipes are free of residue, slag or dirt
hCheck connections with the electrical mains, L-N polarity and
grounding connections
hCheck the mains pressure as indicated in the next paragraph.
Checking the system pressure (minimum sup-
ply pressure) (only for natural gas water heater)
hUnplug the water heater
hRemoving the casing by unscrewing the fastening screws located on
the bottom of the water heater and detaching the casing from the
upper part (Fig. 15)
hRemove the cover that closes the service inlet (located on the shelf
Fig. 11) and insert through the hole the silicon pressure gauge tube
hLoosen by approximately two turns the screw of the pressure tap
upstream of the gas valve and connect the pressure gauge to it
hCarefully close the casing
hTurn the water temperature control knob to the maximum point
hElectrically connect the water heater
hOpen a hot water valve to full capacity
Check the gas pressure referring to the values indicated in the data table.
If the pressure is higher than 15 mbar, calibrate the gas valve.
During measurement a tolerance of +/-0.5 mbar is permitted.
hClose the hot water tap
hDisconnect the pressure gauge and tighten the pressure tap up-
stream of the gas valve.
Fig. 11 - Check mains pressure
service
inlet
pressure tap upstream of
the valve
pressure tap downstream of
the valve
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for TTulpe C-Meister 14 P37 Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of TTulpe C-Meister 14 P37 Eco in the language / languages: English as an attachment in your email.

The manual is 1.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of TTulpe C-Meister 14 P37 Eco

TTulpe C-Meister 14 P37 Eco Usermanual and installation guide - German - 24 pages

TTulpe C-Meister 14 P37 Eco Usermanual and installation guide - Dutch - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info