774516
3
Zoom out
Zoom in
Previous page
1/27
Next page
COMPATIBILITY
The contact sensor works with the Z1 ZigBee Bridge and the ICS-2000.
1. (RE)PLACE THE BATTERY
A Remove the backplate from the contact sensor.
B Open de battery cover using a flat screwdriver.
C Place the included CR2032 battery in the contact sensor. Note the positive
and negative polarity in the compartment. Close the battery cover.
2. INDICATORS
The contact sensor contains a LED indicator (This is not a button) to show the
status of the contact sensor. Please see below the meaning of the dierent
LED indications.
LED FUNCTION TABLE
Connection mode LED will flash once per second
for approximately 1 min.
Connected successfully LED will stop flashing
Sensor reset LED will flash fast
Sensor triggered (When the sensor is
opened for more then 10 mm) LED will flash once
A
B
C
A
A
B
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trust ZCTS-808 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trust ZCTS-808 in the language / languages: All languages as an attachment in your email.

The manual is 9.74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info