461539
10
Zoom out
Zoom in
Previous page
1/48
Next page
10
Operating instructions
Always observe the operating instructions and “Impor-
tant operating notes” prior to starting! The vehicle owner
is responsible for correct operation of the appliance.
The installer or vehicle owner must affix the yellow sticker with
warning information en closed with the appliance to a place
in the vehicle where it is clearly visible to all users (e.g. on the
wardrobe door)! Ask Truma to send you a sticker if necessary.
Trumatic S 3002 (P) Heater
b
e
a
c
h
d
f
g
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Automatic ignition (Trumatic S 3002 P model) or
Dummy cover (Trumatic S 3002 model)
d = Automatic ignition device with battery compartment
(model Trumatic S 3002)
e = Remote ignition display (accessory)
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
In the case of left-handed installation, the parts are arranged
on the other side.
Trumatic S 5002 Heater
b
e
c
a
h
d
f
g
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Dummy cover or Integrated control panel
for second Trumavent fan TEB / TEN
d = Automatic ignition device with battery compartment
e = Remote ignition display (accessory)
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
In the case of left-handed installation, the parts are arranged
on the other side.
Trumatic S 5002 Heater and front case with
flame effect
The flame effect and the Trumatic S 5002 heater can started
up together or separately.
b
e
c
a
h
d
f
g
a = Control knob (Thermostat)
b = Dummy cover or Integrated control panel
for Trumavent fan TEB / TEN
c = Dummy cover or Integrated control panel
for second Trumavent fan TEB / TEN
d = Automatic ignition device with battery compartment
e = Control panel flame effect
f = Window to check flame
g = Thermostat sensor
h = Data plate (remove front case!)
In the case of left-handed installation, the parts are arranged
on the other side.
Taking into operation with the piezo
ignitor (Trumatic S 3002 P only)
1. Turn on gas cylinder and open quick-acting valve in the gas
supply line.
2. Turn control knob (a) to thermostat setting 1 – 10 and press
it down as far as the stop. At the same time keep operating
the piezo ignitor rapidly until the flame ignites.
0
1
0
9
8
7
6
5
4
3
2
1
a
3. Keep the control knob pressed down for a further 10 sec-
onds to allow the safety pilot to operate.
4. Observe through the in spection window for a further
10 seconds so as to check that the flame has not been
extinguished due to air in the line (caused by a change of
gas cylinder).
Wait for 2 minutes before re-igniting, otherwise
risk of misfiring! This also applies if a working heater
goes out and has to be re-lit.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trumatic S 3002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic S 3002 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 4,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trumatic S 3002

Trumatic S 3002 Additional guide - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info