Manual Trumatic E 4000 (page 21 of 88) (English, German, Dutch, Danish, French, Italian, Spanish)

544145

Zoom out

Zoom in

1/88

The installation and repair of the appliance is only to be

carried out by an expert. Read the installation instructions

carefully prior to starting work and observe the instructions!

Non-compliance with installation instructions or

incorrect installation can result in endangerment

of persons and property.

Intended use

This appliance has been designed for installation in vehicles

(mobile homes, caravans, boats, trucks). Other applications

are also possible following consul tation with Truma.

Installation inside busses (vehicle classes M2 and M3) is not

permitted.

Vehicles for class EX/II and EX/III hazardous materials

Combustion heaters for gaseous fuel are not permitted.

Approval

Directive 2004/78/EC stipulates that a safety shut-off device

is required if motor homes are being heated while driving.

The Truma gas pressure control systems SecuMotion /

MonoControl CS satisfy these requirements.

The installation of a safety shut-off device, such as e.g.

the gas pressure control system Truma SecuMotion /

MonoControl CS with the correct gas installation configura-

tion, means that the operation of a type-approved liquid gas

heating system when the vehicle is on the move is approved

throughout Europe in accordance with the EC Directive

2001/56/EC.

The safety shut-off device is also recommended for safety

reasons if caravans are being heated while driving.

The heater is approved for installation in motor vehicles for

transporting passengers (motor caravans in vehicle class M1)

that have no more than 8 seats excluding the driver’s seat, for

trailers (caravans in vehicle class O) and for commercial vehi-

cles (vehicle class N).

The year when the equipment was first taken into oper-

ation must be indicated with a check on the type plate.

Installation instructions

Regulations

Guarantee claims, warranty claims and acceptance of liability

will be ruled out in the event of the following:

modifications to the unit (including accessories),

modifications to the exhaust duct and the cowl,

failure to use original Truma parts as replacement parts and

accessories,

failure to follow the installation and operating instructions.

It also becomes illegal to use the appliance, and in some

countries this even makes it illegal to use the vehicle.

Installation in road vehicles must comply with the legal pro-

visions of the country of use (e.g. for Europe EN 1949 for

vehicles). National directives and regulations (e.g. DVGW

worksheet G 607 for vehicles and G 608 for boats in Germany)

must be complied with.

In the case of vehicles used for commercial purposes, the respec-

tive accident prevention regulations issued by the professional as-

sociations are to be adhered to (e.g. for Germany BGV D 34).

For further details on the rules and regulations in the respec-

tive country of desig-nation, please contact our agencies

abroad (see Truma Service Booklet or www.truma.com).

Notes on the installation in commercial

vehicles

The TÜV-tested cylinder holder

(part no. 39742-00) is a constituent

of the type approval for Trumatic E

heaters in accordance with heater

directive 2001/56/EC. Here it is

stated that 2 gas cylinders with a

contents of max. 15 kg can be con-

nected and used for operating the

heaters while the vehicle is moving.

For the protection of the cylinder

valve and the gas pressure regula-

tor, just the protective cover pro-

vided with the cylinder bracket

is required.

For protection against theft or for

reasons of appearance, the gas

cylinder can also be concealed us-

ing the lockable cylinder cabinet

(part no. 39010-21100). The cabinet

is bolted with the cylinder bracket

to the vehicle frame.

When installing the heater in special vehicles (e.g. vehicles for

transporting hazardous goods), the respective regulations for

such vehicles must be observed.

Notes on installation in driver's cab

In the case of heating systems where the waste gas is guided

below the vehicle floor, the waste gas cowl outlet must be

attached up to the side or rear edge of the driver‘s cab or the

vehicle. Steps must be taken to ensure that no waste gases

can enter the inside of the vehicle (e.g. from below through

the vehicle floor).

Model-related assembly instructions can be obtained from Truma.

In Germany, for tank vehicles carrying hazardous goods in the

field of application covered by the ADR, the appliance is only

approved with the Truma control unit.

–

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic E 4000 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 6,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trumatic E 4000 Manual

Product: