Manual Trumatic E 4000 (page 16 of 88) (English, German, Dutch, Danish, French, Italian, Spanish)

544145

Zoom out

Zoom in

1/88

Items sensitive to heat (e.g. spray cans) must not be stored

in the installation area, since excess temperatures may under

certain circumstances be incurred there.

Only pressure control equipment that complies with EN 12864

(in vehicles) and EN ISO 10239 (for boats) with a fixed delivery

pressure of 30 mbar must be used for the gas system. The

flow rate of the pressure control device must correspond to at

least the maximum consumption of all devices installed by the

system manufacturer.

We recommend the Truma gas pressure control systems

SecuMotion / MonoControl CS for vehicles and the Truma

gas pressure control systems DuoComfort / DuoControl CS

for dual-cylinder gas systems.

We recommend the gas pressure control systems Truma

SecuMotion / MonoControl CS for vehicles and the gas pres-

sure control systems Truma DuoComfort / DuoControl CS for

dual-cylinder gas systems.

At temperatures of around 0 °C or less the gas pressure regu-

lator and the changeover valve must be operated using the

EisEx de-icing system.

Controller connecting hoses that meet national regulations

must always be used in the respective country for which the

equipment is destined. These hoses must be checked regu-

larly for brittleness. Winter-proof special hoses must always

be used if the equipment is operated during the winter.

If the pressure regulator is exposed to weather conditions –

especially on trucks – always make sure to protect the regula-

tor using the Truma protective cover (standard accessory in

truck attachment kit).

Important operating notes

If the cowl has been placed near or directly beneath an open-

ing window, the device must be equipped with an automatic

shut-off device in order to prevent operation with the window

open.

The integrity and tight fit of the exhaust gas double duct must

be checked regularly, particularly at the end of long trips. Also

check the mounting of the appliance and the cowl.

Following a blow-back (misfire) always have the ex-haust gas

system checked by an expert!

If appliances are assembled on the outside of the vehicle,

regularly check the flexible air ducts for damage. A damaged

duct could lead to exhaust gas entering the vehicle.

Always keep the cowl for conducting exhaust gas and supply-

ing combustion air, free from contamination (slush, leaves etc.).

The installed temperature limiter shuts off the gas supply if the

appliance becomes too hot. Therefore do not shut the warm

air outlets and the opening for the returning circulating air.

If the electronic control p.c.b. is defective, return it well

packed. If you fail to do so, guarantee claims shall no longer

be valid. Only use original p.c.b. as a spare part!

Directive 2004/78/EC stipulates that a safety shut-off device is

required if motor homes are being heated while driving.

The Truma gas pressure control systems SecuMotion /

MonoControl CS satisfy these requirements.

If no safety shut-off device (e.g. for the Truma gas pres-

sure control system SecuMotion / MonoControl CS) has

been installed, the gas cylinder needs to be closed when driv-

ing and appropriate signs must be displayed in the cylinder

cupboard and close to the operating part.

The safety shut-off device is also recommended for safety

reasons if caravans are being heated while driving.

For conducting the exhaust gas under the floor, the vehicle

floor must be sealed tight. There must also be three open

sides beneath the vehi-cle floor to ensure unhindered escape

of the exhaust gas (snow, aprons etc.).

Instructions for mobile heating appliances

Truma mobile cargo-hold heating units have been approved

by the professional associations. They are complete heating

appliances which are simply placed in the cargo hold with the

cargo as the need arises. The heaters are completely inde-

pendent and require no external connections of any kind.

Approval covers only original mobile cargo-hold heaters

manufactured by Truma. Reproductions by third parties have

not been approved! Truma refuses to give any guarantee of

safety and correct functioning in respect of a reproduction

mobile cargo-hold heater.

The use of the appliance in vehicles used for the transport of

hazardous goods is not permitted.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic E 4000 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 6,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trumatic E 4000 Manual

Product: