Manual Truma Saphir compact (page 16 of 60) (English, German, Dutch, Danish, French, Italian, Spanish)

489373

Zoom out

Zoom in

1/60

The installation and repair of the appliance is only to be

carried out by an expert. Read the installation instructions

carefully prior to starting work and observe the instructions!

Intended use

This device was designed for installation inside mobile homes

and caravans. Any other applications are only possible after

consultation with Truma.

Approval

The air conditioner Truma Saphir compact satisfies the basic

requirements of the EN 14511, and the safety and environ-

mental stipulations of the EN 378.

Declaration of conformity

The device satisfies the requirements of the following

EC Directives:

EMC Directive 2004/108/EC

Low-Voltage Directive 2006/95/EC

Noise Suppression in Vehicles 2004/104/EC, 2005/83/EC,

2006/28/EC

Type approval number e1 03 4392

Pressurised Equipment Directive 97/23/EC

End-of-Life Vehicle Directive 2000/53/EC

Regulations

Guarantee claims, warranty claims and acceptance of liability

will be ruled out in the event of the following:

modifications to the unit (including accessories),

failure to use original Truma parts as replacement parts

and accessories,

failure to follow the installation and operating instructions.

Choice of location

The device is in principle to be installed in such a way that it is

readily accessible at all times for servicing work, and can be

easily removed and installed.

In installation situations where space is restricted, the

2 connecting cables (power cable and IR receiver cable)

must be long enough for the system to be withdrawn with the

cables attached and the cover opened.

20 mm

30 mm

20 mm

290 mm

440 mm

200 mm

790 mm

In order to achieve homogeneous vehicle cooling, the

air conditioning unit must be installed in a central loca-

tion in a false floor or the like so that the cold air is evenly

distributed.

The air conditioning unit is attached to the floor, which must

be level and smooth. The air inlet (LE), the air outlet (LA) and

the muff (11) may need to be fitted with additional gaskets if

the unit is attached to a grooved floor.

–

Manufacturer’s terms of warranty

1. Case of warranty

The manufacturer grants a warranty for malfunctions in the

appliance which are based on material or production faults.

In addition to this, the statutory warranty claims against the

seller remain valid.

A claim under warranty shall not pertain:

for parts subject to wear and in cases of natural wear and

tear,

as a result of using parts that are not original Truma parts in

the units,

as a consequence of failure to respect Truma instructions

for installation and use,

as a consequence of improper handling,

as a consequence of improper transport packing, not

arranged by Truma.

2. Scope of warranty

The warranty is valid for malfunctions as stated under

item 1, which occur within 24 months after conclusion of

the purchase agreement between the seller and the final

consumer. The manufacturers will make good such defects

by subsequent fulfilment, i.e. at their discretion either by

repair or replacement. In the event of manufacturers provid-

ing service under warranty, the term of the warranty shall not

re commence anew with regard to the repaired or replaced

parts; rather, the old warranty period shall continue to run.

More extensive claims, in particular claims for compensatory

damages by purchasers or third parties, shall be excluded.

This does not affect the rules of the product liability law.

The manufacturer shall bear the cost of employing the Truma

customer service for the removal of a malfunction under war-

ranty – in particular transportation costs, travelling expenses,

job and material costs, as long as the service is carried out in

Germany. The warranty does not cover customer service work

in other countries.

Additional costs based on complicated removal and installa-

tion conditions of the appliance (e.g. removal of furniture or

parts of the vehicle body) do not come under warranty.

3. Raising the case of warranty

The manufacturer's address is:

Truma Gerätetechnik GmbH & Co. KG,

Wernher-von-Braun Strasse 12,

85640 Putzbrunn.

In Germany, always notify the Truma Service Centre if prob-

lems are encountered; in other countries the relevant service

partners should be contacted (see Truma Service Booklet

or www.truma.com). Any complaints are to be described in

detail. In addition, the properly completed guarantee certifi-

cate is to be presented, or the factory number of the unit and

the date of purchase given.

To avoid transport damage, the device may only be dispatched

after agreement with the Truma Service Centre in Germany or

with the particular service partner concerned abroad. The risk

for possible transport damage will otherwise be borne by the

consignor.

If it is a case of warranty, the factory shall bear the cost for

the delivery to the factory and the cost for returning the ap-

pliance to the customer. If the damage is deemed not to be

a warranty case, the manufacturer shall notify the customer

and shall specify repair costs which shall not be borne by the

manufacturer; in this case, the customer shall also bear the

shipping costs.

–

Installation instructions

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Saphir compact in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Saphir compact Manual

Product: