Manual Truma Saphir compact (page 12 of 60) (English, German, Dutch, Danish, French, Italian, Spanish)

489373

Zoom out

Zoom in

1/60

Before starting to use the device, it is essential that the

Operating Instructions and “Safety instructions” be read

carefully. The vehicle owner is responsible for ensuring that

the device can be operated in the proper manner.

Infrared (IR) remote handset

+/– = Setting

Operating level,

Timer, Temperature,

Fan speed

a = MODE

Operating mode

selector switch

FAN MODE

Ventilation only

COOL MODE

Cooling and ventilation

b = No function

c = TEMP.

Desired interior

temperature

16 °C to 31 °C

Hr.

COOL

MODE

COOL LOW

TEMP.

TIMER

COOL HIGH

COOL

FAN LOW

FAN HIGH

°C

TEMP.

MODE

TIMER RESEND

ON / OFF

Saphir compact

d = No function

e = TIMER off

Set timer to 1 to 15 hours

f = RESEND

Send the settings of the remote control

to device again

g = ON / OFF

On / Off switch

Taking into operation

Before switching on, be sure to check that the campsite pow-

er supply fusing is sufficient for 700 W (230 V – at least 3 A).

In order to prevent the power cable for the caravan from

overheating (minimum cross-section 3 x 2.5 mm²) the

cable drum must be fully unwound.

The remote handset must always be pointed at the infrared (IR)

receiver in order to execute the individual switching commands.

1. Switch the Saphir compact on using button “g” on the

remote handset. The “COOL MODE” that was previously

selected using the remote handset is automatically used.

2. Set the desired operating mode using the button “a”.

FAN MODE: Ventilation only without cooling.

Select the required fan speed FAN LOW or

FAN HIGH using the “+” and “–” buttons.

COOL MODE: Cooling with 3 levels.

The room temperature can be individually

adjusted. The green indicator lamp on the

receiver indicates that the compressor is

running. Select the required cooling setting

COOL LOW, COOL or COOL HIGH using

the “+” and “–” buttons.

The COOL LOW setting acts as a sleep function. The

internal and external fans operate at a slower speed in

this mode in order to minimise the amount of noise that is

generated.

3. Select the required room temperature using the “c”, “+”

and “–” buttons.

When the room temperature that was selected using the

remote handset is reached in cooling mode, the compressor

switches off and the green indicator lamp in the receiver goes

off. The circulation fan continues to run in order to provide

ventilation. If the room temperature setting is exceeded the

device automatically reverts to cooling mode.

Switching off

To switch off, press the button “g” on the remote control

once again.

If the air conditioning unit is switched on again within

approximately 3 minutes, the green indicator lamp

flashes. The recirculated air fan runs, and the compressor is

activated after a maximum of 3 minutes.

Timer off

The air conditioning unit deactivation time can be set up to

15 hours in advance using the integrated timer, starting from

the current time.

To carry out programming, first switch the device to remote

control mode with the switch “g”.

Then set the operating mode and the room temperature using

buttons “a”, “c”, “+”, and “–”.

Then select the required deactivation time (1 – 15 hours) using

the “e” button (TIMER).

The programming is not active unless the air conditioning

unit is switched on. The remote handset can be deactivated

by covering the infrared transmitter on the front of the remote

handset. This prevents unintentional air conditioning unit de-

activation and accidental deactivation time reprogramming.

IR receiver and manual on / off

There is an additional pushbutton on the receiver (m), with

which the unit can also be switched on and off without the

remote control (e.g. with a ballpoint pen).

If the unit is switched on using

this pushbutton, the system

is automatically reset to the

factory settings (COOL HIGH,

TEMP. 21 °C).

LED 2

LED 1

Saphir compact

Operating indicator

LED 1 green illuminated Cooling (COOL LOW, COOL

or COOL HIGH)

–

LED 1 green short flash The recirculated air fan runs,

and the compressor is also

activated after a maximum of

3 minutes

–

LED 1 green flashes briefly Only during operation with

power inverter: Waits until

engine starts or function is

changed using remote handset

–

LED 2 red short flash Data transfer in progress or

supply voltage being

connected

–

LED 2 red illuminated Fault–

Operating instructions

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Saphir compact in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,67 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Saphir compact Manual

Product: