590216

Truma Mover XT 4 Manual

23
Zoom out
Zoom in
Previous page
1/88
Next page
23
Adapting the mud guards to the Mover®
1. Remove the mud guards.
2. Fit Mover® in accordance with the following installation
instructions.
3. Determine dimensions a and b and transfer to mud guards.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Determining the cut-out sizes
a
b
Mover® XT / XT2
Mo
ver
®
X
T
2
XT / X
X
a
b
Mover® XT4
Figure 15
Cut out the template at the end of the installation instructions,
place onto mud guard, transfer contour and cut out (figure 6).
Pay attention to left and right sides!
If necessary, make recesses in the mud guard for the apron
contour. Secure the mud guard 300 mm from the tyre on the
underside of the caravan.
Fitting the drive elements
The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions.
Remove all components from packing and place on the floor.
Figure 16
In order to guarantee the validity of the general operat-
ing permit (ABE), the left and right data plates (f) must
be present on the cross-struts (4 x).
f
Figure 17
Mark the connection pipes in the centre. Loosely connect the
drive assemblies with connection pipes.
Do not screw in the supplied threaded bolts (g) yet.
g
Figure 18
Place the drive assemblies with the connection pipe and
mounting kit (b) on the vehicle frame and bolt them on with
the two bolts (c) in such a way that it is just possible to move
them along the frame.
The gripper (a) must be lying flat against the chassis
frame (e) in its entirety and also flat against the leg (d).
c
a
b
d
e
Figure 19
b
Figure 20
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets as accessories in order to compen-
sate for this.
Spacer set 30 mm, part no. 60030-95000,
Spacer set 60 mm, part no. 60030-95100,
Make sure that there is adequate ground clearance (at least
110mm).
… 23 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma Mover XT 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma Mover XT 4 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish as an attachment in your email.

The manual is 11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info