14
Trouble-shooting
In the event of a fault, please contact your dealer or the Truma-
Service (see page 48).
Before calling customer service, please check the following:
1. Is the battery in the remote handset in good condition?
2. Is the caravan battery in good condition and fully charged?
Do not use the Mover if the battery voltage is below 10,2 V DC.
Changing the battery in the remote handset
Please be sure to use a leak proof
E-Block 9 V battery only,
type 6 LR 61, 6 AM 6, MN 1604.
When fitting a new battery ensure
the polarity is correct!
A dead and used battery may
leak and damage the remote
handset. Remove the battery if the
handset is not going to be used for
an extended period.
No claims under guarantee will be considered for
damage caused by a leaking battery.
Before throwing away a defective handset, it is essential that
the battery is removed and disposed of in proper manner.
Aligning the electronic control unit and the
remote handset
After replacing a electronic control unit or a remote handset
the individuals must be aligned by the following procedure.
1. Ensure the Mover is installed in accordance with the installation
instructions. Ensure the caravan battery is connected, in good
condition and supplies 12 V, DC to the electronic control unit.
2. Press the reset button (h) until the green light (i) flashes.
3. Press the red button (a) on the handset twice within one
second. This will align the handset and installed relay box.
If the reset button (h) is pressed incorrectly, the red and green
light will flash alternately. In this case, wait until both lights
stop flashing, then press the reset button (h) again and hold
until just the green light flashes.
Installation instructions
Please fold out the page with diagrams!
Read the installation instructions prior to starting work and
follow them carefully!
Intended use
The Twin Mover was designed for installation in twin axle
caravans/trailers with a total weight up to 2250 kg.
Installation using the standard installation kit is only possible
on caravans/trailers with the following dimensions.
all dimensions in mm
* With shock absorbers fitted
**Without shock absorbers fitted
+ With fully loaded vehicle
A distinction is made between L-profile and U-profile
frames as shown in the illustration.
Measuring the frame height
Measuring the frame height (Y), measured at point (X)
Euro Mover Tandem X = 180 mm
Determining the installation type
1. Standard installation
Standard installation is used with an L-profile chassis and a
frame height (Y) of approx. 185 mm. No special accessories
are required.
2. Installation with chassis with U-profile
Standard installation is used with a U-profile chassis and a
frame height (Y) of approx. 185 mm. A U-profile frame kit is
needed to compensate for the profile edge.
3. Installation with chassis with L-profile and frame
height of between 140 and 185 mm
With a chassis with a frame height (Y) of 140 mm to 185 mm,
1, 2 or 3 spacer plate sets and and the set of screws are
needed to compensate for the height.