629586

Truma MonoControl CS Gastank Manual

12
Zoom out
Zoom in
Previous page
1/60
Next page
12
Checking for leaks in the low pressure
section
(maximum test pressure 150 mbar)
The test must be conducted by a technician!
– Turn off all consumers.
– Open stop valves and, if present, the gas remote switch.
– Remove the threaded cap from the test connection (b) and
connect the test pump with test hose to the test connection.
b
Figure 2
– Carry out the check for leaks (e.g in Germany in accordance
with G 607).
– If the gas system leaks, close the extraction valve and have
the gas system repaired immediately by an expert. Do not
open the extraction valve until repair is complete.
– When testing is complete, screw the threaded cap back
onto the test connection.
Operating instructions
Start-up
Open the gas remote switch if present.
1. Open the extraction valve.
2. If necessary (e.g. after a new installation), firmly press the
green reset button (crash sensor triggering element reset)
on the the MonoControl CS gas tank for about 5 seconds.
2.
1.
Figure 1
Checking for leaks in the high-pressure
section
The screw joints must be tested for leaks using suitable
means (such as a leak-finder spray in accordance with
EN 14291).
The operator is responsible for this.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Truma MonoControl CS Gastank at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Truma MonoControl CS Gastank in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info