Manual Truma Combi E CP plus ready (page 13 of 60) (English, German, Dutch, Danish, French, Italian, Swedish)

565804

Zoom out

Zoom in

1/60

Always observe the operating instructions and “Impor-

tant operating notes” prior to starting! The digital / ana-

logue control panels are described in separate operating

instructions. The vehicle owner is responsible for correct

operation of the appliance.

The installer or vehicle owner must apply the yellow sticker

with the warning information, which is enclosed with the ap-

pliance, to a place in the vehicle where it is clearly visible to

all users (e.g. on the wardrobe door)! Ask Truma to send you

stickers, if necessary.

Before using for the first time, it is essential to flush the

entire water supply system through with clean water. If

the heater is not being used, always drain the water contents

if there is a risk of frost! There shall be no claims under

guarantee for damage caused by frost!

Room thermostat

To measure the room temperature, an external room tempera-

ture sensor (2) is located in the vehicle. The position of the

sensor is determined by the vehicle manufacturer depending

on the vehicle model. More information can be found in the

operating instructions for your vehicle.

Fig. 2

The thermostat setting at the control panel depends on the

personal heating requirement and the design of the vehicle,

and must be individually determined.

Safety/drain valve

A. FrostControl

(Safety/drain valve with integral frost protection /

optional in UK version)

FrostControl is a currentless safety/drain valve. When there

is a danger of frost, it automatically drains the contents of

the boiler through a drainage socket. If excessive pressure is

present in the system, pressure will be automatically intermit-

tently equalized through the pressure relief valve.

Fig. 3

a = Rotary switch position “On”

b = Push button position “Closed”

c = Push button position “Drain”

d = Drainage socket (led outside through floor of vehicle)

Opening the safety/drain valve

– Turn the rotary switch by 180° until it engages, whereby the

push button pops out (position c). The water from the boiler

will be released through the drainage socket (d).

The FrostControl drainage socket (d) must be free of contami-

nation (slush, ice, leaves, etc.) at all times so the water can

drain out easily! There shall be no claims under guarantee

for damage caused by frost!

Closing the safety/drain valve

– Check whether the rotary switch is set to “On” (position a),

i.e. parallel to the water connection and engaged.

– Close the safety/drain valve by pressing the push button.

The push button must engage in position (b) "closed".

Only when the temperature at the safety/drain valve is above

approx. 7 °C can it be closed manually with the push button

(position b) and the boiler filled.

Truma supplies a heating element (part no. 70070-01) as an

accessory, which is inserted into the FrostControl and fixed

in place with a retaining bracket. This heating element heats

Combi the FrostControl to approx. 10°C when the Combi is

switched on. This means that the boiler can be filled after a

shorter time, irrespective of the temperature in the installation

compartment.

Automatic opening of the safety/drain valve

If the temperature at the drain valve is below about 3 °C, it

will open automatically and the push button pops out (posi-

tion c). The water from the boiler will be released through the

drainage socket (d).

B. Safety/drain valve

(Safety/drain valve without frost protection /

standard in UK version)

The safety/drain valve automatically equalises the pressure in

the event of overpressure in the system. When this occurs,

the water is drained to the outside in intermittent bursts via a

drainage socket.

This safety/drain valve does not protect the water

container from frost damage.

Fig. 4

a = Lever in position "Operational – closed“

b = Lever in position "Operational – closed“

c = Lever in position "Drain"

d = Drainage socket (led outside through floor of vehicle)

Opening the safety/drain valve

– Move lever to position (c) - vertical. The water from the

boiler drains through the drainage socket (d).

The drainage socket (d) of the safety/drain valve must be free

of contamination (slush, ice, leaves, etc.) at all times so the

water can drain out easily! There shall be no claims under

guarantee for damage caused by frost!

Opening the safety/drain valve

– Move lever to position (a) or (b) - horizontal.

Operating instructions

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Combi E CP plus ready in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish as an attachment in your email.

The manual is 5,09 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Combi E CP plus ready Manual

Product: