Manual Truma BM 14 (page 15 of 68) (English, German, Dutch, Danish, French, Italian, Spanish)

489383

Zoom out

Zoom in

1/68

Technical data

(determined in accordance with EN 624 or Truma test

conditions)

Type of gas

Liquid gas (propane / butane)

Operating pressure

30 mbar (see type plate)

Water contents

10 or 14 litres

Heating time up to approx. 70 °C

(10 litres)

Gas operation: approx. 34 Min.

Electric operation: approx. 45 Min.*

Gas and electric operation: approx. 25 Min.*

Heating time up to approx. 70 °C

(14 litres)

Gas operation: approx. 50 Min.

Electric operation: approx. 72 Min.*

Gas and electric operation: approx. 38 Min.*

Water pressure

up to max. 2.8 bar

Rated thermal output

1500 W

Gas consumption

120 g/h

Current input at 12 V

Ignition: 0.17 A

Heating up: 0.08 A

Stand-by: 0.04 A

Current input at 230 V*

850 W (3.7 A)

* BM 10 EL, BM 14 EL only

Declaration of conformity

The Truma boat water heater model has been tested and ap-

proved through the DVGW and fulfils the EC gas appliance

guidelines (90/396/EEC) as well as the associated EC guide-

lines. The CE Ident. No. is available for EU countries:

CE-0085AO0048

EC Type Approval

e1 03 2604

Dimensions

350

440

320

14 l

260

10 l

50 – 200 cm

30 – 150 cm

All dimensions in mm.

The right to effect technical modifications is reserved!

Manufacturer’s terms of warranty

1. Case of warranty

The manufacturer grants a warranty for malfunctions in the

appliance which are based on material or production faults.

In addition to this, the statutory warranty claims against the

seller remain valid.

A claim under warranty shall not pertain:

for parts subject to wear and in cases of natural wear

and tear,

as a result of using components in the units that are not

original Truma parts and using unsuitable gas pressure

regulators,

as a consequence of failure to respect Truma instructions

for installation and use,

as a consequence of improper handling,

as a consequence of improper transport packing.

2. Scope of warranty

The warranty is valid for malfunctions as stated under

item 1, which occur within 24-months after conclusion of

the purchase agreement between the seller and the final

consumer. The manufacturers will make good such defects

by subsequent fulfilment, i.e. at their discretion either by

repair or replacement. In the event of manufacturers provid-

ing service under warranty, the term of the warranty shall not

re commence anew with regard to the repaired or replaced

parts; rather, the old warranty period shall continue to run.

More extensive claims, in particular claims for compensatory

damages by purchasers or third parties, shall be excluded.

This does not affect the rules of the product liability law.

The manufacturer shall bear the cost of employing the Truma

customer service for the removal of a malfunction under war-

ranty – in particular transportation costs, travelling expenses,

job and material costs, as long as the service is carried out in

Germany. The warranty does not cover customer service work

in other countries.

Additional costs based on complicated removal and installa-

tion conditions of the appliance (e.g. removal of furniture or

parts of the vehicle body) do not come under warranty.

3. Raising the case of warranty

The manufacturer's address is:

Truma Gerätetechnik GmbH & Co. KG,

Wernher-von-Braun Strasse 12,

85640 Putzbrunn.

In Germany, always notify the Truma Service Centre if prob-

lems are encountered; in other countries the relevant service

partners should be contacted (see Truma Service Booklet or

www.truma.com). Any complaints are to be described in de-

tail. In addition, the properly completed guarantee certificate

is to be presented, or the factory number of the unit and the

date of purchase given.

In order for the manufacturers to be able to determine wheth-

er an incident subject to guarantee has occurred, the end user

must, at his own risk, bring the device to the manufacturers or

send it to them. If there is damage to heaters (heat exchang-

ers), the gas pressure regulator must also be sent back to the

factory.

In instances of the device being sent to the works, dispatch is

to be effected by freight transport. In cases under guarantee,

the works shall bear the transport costs or the costs of deliv-

ery and return. If the damage is deemed not to be a warranty

case, the manufacturer shall notify the customer and shall

specify repair costs which shall not be borne by the manufac-

turer; in this case, the customer shall also bear the shipping

costs.

–

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma BM 14 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 0,78 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma BM 14 Manual

Product: