Manual Truma B 14 (page 9 of 44) (English, German, Dutch, Danish, French, Italian, Spanish)

489380

Zoom out

Zoom in

1/44

Only pressure control equipment that complies with EN 12864

(in vehicles) with a fixed delivery pressure of 30 mbar must be

used for the gas system. The flow rate of the pressure control

device must correspond to at least the maximum consump-

tion of all devices installed by the system manufacturer.

At temperatures of around 0 °C or less the gas pressure regu-

lator and the changeover valve should be operated using the

EisEx regulator heater.

We recommend Truma accessories for the gas supply for

vehicles.

Regulator connecting hoses that meet national regulations

must always be used in the respective country for which the

equipment is destined. These hoses must be checked regu-

larly for brittleness. Winter-proof special hoses must always

be used if the equipment is operated during the winter.

Pressure regulating devices and hoses must be replaced

with new ones no more than 10 years after their date of

manufacture (every 8 years if used commercially). This is the

responsibility of the operator.

Important operating notes

If the cowl has been placed near or directly beneath an opening

window, the device must be equipped with an automatic shut-

off device in order to prevent operation with the window open.

Always mount the cowl cap if the water heater is not being

used. Non-observance of this point can lead to the function

of the appliance being impaired through water, dirt or insects.

There shall be no claim under guarantee if this point is not

observed.

Before every journey, put on the cowl cover when the

boiler is switched off. Please ensure that it is secure and

has locked into place (risk of accident). Defective cowl caps

must not be used.

Always remove the cowl cap prior to operating the water heater!

If just the cold water system is being used, without water

heater, the heater tank is also filled up with water. In order

to avoid damage through frost, the water contents must be

drained by actuating the safety/drain valve, also when the

heater has not been used. As an alternative, two shutoff

valves, resistant to hot water, can be fitted in front of the cold

and hot water connection.

When connecting to a central water supply (rural or city mains),

a pressure reduction valve must always be installed to prevent

pressures above 2.8 bar from developing in the water heater.

In Germany, always notify the Truma Service Centre if prob-

lems are encountered; in other countries the relevant service

partners should be contacted (see Truma Service Booklet or

www.truma.com).

Safety instructions

The use of upright gas cylinders from which gas is taken in

the gas phase is mandatory for the operation of gas regula-

tors, gas equipment and gas systems. Gas cylinders from

which gas is taken in the liquid phase (e.g. for fork lifts) must

not be used, since they would result in damage to the gas

system.

In event of leaks in the gas system or if there is a smell of gas:

extinguish all naked flames

do not smoke

switch off the appliances

shut off the gas cylinder

open windows and door

do not actuate any electrical switches

have the entire system checked by an expert!

Repair jobs are only to be carried out by an expert!

During use, please observe the regulations of EN 60335-1: 2010,

according to which this device has not been designed for

use by people (including children) who have restricted physi-

cal, sensory or metal abilities or a lack of experience and / or

knowledge, unless they are supervised by a person respon-

sible for their safety or have received instructions from that

person as to how the device is to be used.

Children should be supervised to ensure they do not play with

the device.

To avoid risk caused by unintentional resetting of the

overtemperature sensor, the device may not be supplied

via an external switching device such as a digital timer or be

connected with a circuit that is regularly switched on and off

by any kind of equipment.

Guarantee claims, warranty claims and acceptance of liability

will be ruled out in the event of the following:

modifications to the unit (including accessories),

modifications to the exhaust duct and the cowl,

failure to use original Truma parts as replacement parts and

accessories,

failure to follow the installation and operating instructions.

The gas supply’s operating pressure (30 mbar) must be the

same as the unit’s operating pressure (see type plate).

Liquid gas installations must accord with the technical and

administrative regulations of the individual country in which

they are to be used (e.g. EN 1949 for motor vehicles). National

regulations and rules (e.g. DVGW work sheet G 607 in Ger-

many) must be followed.

In Germany, the gas system must be retested every 2 years by

a liquid gas specialist (DVFG, TÜV, DEKRA).

The vehicle owner is always responsible for arranging the

inspection.

Liquid gas equipment must not be used when refuelling, in

multi-storey car parks, in garages or on ferries.

During the initial operation of a brand new appliance (or after

it has not been used for some time), a slight amount of fumes

and smell may be noticed for a short while. This can be rem-

edied by running the heater at maximum output and ensuring

adequate room ventilation.

If the burner makes an unusual noise or if the flame lifts off, it

is likely that the regulator is faulty and it is essential to have it

checked.

Heat-sensitive objects (e.g. spray cans) must not be stored in

the vicinity of the boiler, since high temperatures may under

certain circumstances be induced in such locations.

–

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma B 14 in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 2,36 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Truma B 14

Truma B 14 Installation Guide - English, German, Dutch, Danish, French, Italian, Spanish - 24 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma B 14 Manual

Product: