753341
11
Zoom out
Zoom in
Previous page
1/14
Next page
EN 11
cordless glue gun PGGS 10-20V
Gluing
Warning of hot surface
The nozzle might still be hot after use. Glue coming out
of the nozzle can be hot. Risk of burns.
Do not touch the nozzle bare-handed!
Wear protective gloves!
Info
When further glue sticks are pushed in, the device
requires a little more time for heating up than during
initial use. Hardened glue residues can block the feed
channel.
Info
The surfaces to be glued must be clean, dry and free of
grease.
The status LED is illuminated in green.
1. Allow the glue gun to heat up. Push a glue stick suitable
for the material into the feed channel(1) from the rear.
2. Pull the feed trigger(13) to control the flow of glue for the
intended task.
13
3. Apply the glue in dots or lines.
4. Immediately press the two workpieces to be bonded
together for approx.30seconds.
ðAfter approx.5minutes the glue joint will be able to
withstand loads.
Shutdown
Switch off the device.
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
If required, allow the device to cool down.
Remove the battery from the device (see Start-up chapter).
Clean the device according to the Maintenance chapter.
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation Article number
Multiflex 20V 2.0Ah spare battery 6.200.000.303
Multiflex 20V 4.0Ah spare battery 6.200.000.320
Glue sticks Ø11mm/ 150mm set1,
transparent
6.230.001.102
Glue sticks Ø11mm/ 150mm set2,
coloured
6.230.001.111
Glue sticks Ø11mm/ 150mm set3,
glitter
6.230.001.121
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
This is not a fault. These phenomena disappear after a
brief runtime.
The battery does not charge:
Check whether the battery is inserted correctly in the quick
charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
Check the power connection.
Check the power cable and mains plug for damage.
Check the on-site fusing.
Check the quick charger for damage. If the quick charger
is damaged, stop using it. Contact the Trotec customer
service.
Check the battery terminals for dirt. Remove any dirt.
The battery might be defective and have to be replaced.
Only use batteries of the same type.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PGGS 10-20V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PGGS 10-20V in the language / languages: English as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PGGS 10-20V

Trotec PGGS 10-20V User Manual - German - 16 pages

Trotec PGGS 10-20V User Manual - Dutch - 15 pages

Trotec PGGS 10-20V User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info