753916
12
Zoom out
Zoom in
Previous page
1/20
Next page
12 EN
angle grinder PAGS 10-230
2. Turn the guard(8) into the working position. Make sure
that the open side of the guard points towards the
workpiece. The closed side of the guard must always point
to the user.
8
3. Close the locking lever(12).
12
4. Check whether the guard(8) is properly locked in place. It
must be impossible to rotate the guard.
You can increase the clamping force of the lock by
tightening the adjusting screw(10).
10
8
Tool change
The cutting disc for metal is preassembled.
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket!
Do not touch the mains plug with wet or damp hands.
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Warning of hot surface
The insertion tool might still be hot after the
application. Burn hazard when touching the insertion
tool.
Do not touch the insertion tool bare-handed!
Wear protective gloves!
To change the cutting disc, please proceed as follows:
üThe spindle is at a standstill and the cutting disc is no
longer rotating.
1. Press the spindle lock(1) to block the gears.
2. Slowly turn the clamping nut(15) to the locking point until
the lock is fixed. Press and hold the spindle lock(1).
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PAGS 10-230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PAGS 10-230 in the language / languages: English as an attachment in your email.

The manual is 3,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PAGS 10-230

Trotec PAGS 10-230 User Manual - German - 22 pages

Trotec PAGS 10-230 User Manual - Dutch - 22 pages

Trotec PAGS 10-230 User Manual - French - 22 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info