728005
15
Zoom out
Zoom in
Previous page
1/23
Next page
EN 15
air cooler PAE 30
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation Article number
Evaporation filter PAE30 7.710.000.044
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
Check the power connection.
Check the power cable and mains plug for damage.
Check the on-site fusing.
Wait for 10minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device works with reduced or no capacity:
Check the position of the horizontal ventilation flaps. They
should be opened to the maximum.
Check the air filter for dirt. If necessary, clean or replace
the air filter.
Check the minimum distance to walls or other objects.
Position the device a little more in the room's centre if
required.
The device is running, but there is no air cooling or pump
operation:
Check whether air cooling mode is activated.
Check the filling level of the water tank (see chapter Filling
the water tank).
Check whether there are any objects blocking the pump
inlet. Make sure that the pump inlet is not blocked.
In case the pump does not operate despite a correctly filled
water tank and activated air cooling mode, the pump might
be defective. Please contact the customer service.
Make sure that the pump is correctly installed and secured
in the water tank (see chapter Filling the water tank).
Water is leaking:
Check the device for leaks.
Check the water tank for tight fit.
The swing function is not working:
The swing function motor might be defective. Please
contact the customer service.
The device is loud or vibrates:
Check whether the device is set up in a stable and upright
position.
The device does not respond to the infrared remote control:
Check whether the distance between remote control and
device is too large and reduce it if necessary.
Make sure there are no obstacles, such as furniture or
walls, between the device and the remote control. Ensure
visual contact between device and remote control.
Check the charging status of the batteries and change
them if required.
If the batteries have just been changed, check them for
correct polarity.
Your device still does not operate correctly after these
checks?
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Error codes
The following error messages can be displayed on the segment
display:
Error code Cause Remedy
E0 Error in the control
circuit board
Disconnect the device
briefly from the mains.
Should the error still be
displayed after the
restart, please contact
the customer service.
P3 Holder for air filter
not inserted
Insert the holder for the
air filter.
Do not operate the
device without an
inserted evaporation and
air filter!
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PAE30 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PAE30 in the language / languages: English as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PAE30

Trotec PAE30 User Manual - German - 22 pages

Trotec PAE30 User Manual - Dutch - 21 pages

Trotec PAE30 User Manual - French - 23 pages

Trotec PAE30 User Manual - Italian - 22 pages

Trotec PAE30 User Manual - Polish - 21 pages

Trotec PAE30 User Manual - Turkish - 21 pages

Trotec PAE30 User Manual - Spanish - 22 pages

Trotec PAE30 User Manual - Finnish - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info