727840
10
Zoom out
Zoom in
Previous page
1/13
Next page
10 EN
radiant heater IR 2550 S / IR 2570 S
Setting the timer
The timer allows you to program an automatic switch-off time in
increments of1h up to24h at any heating level.
Procedure for IR2550S
ü The device is switched on.
1. Press the Timer button(8) several times to set the desired
number of hours until automatic switch-off.
ð The operating light(7) flashes.
ð The segment display(10) briefly indicates the number of
hours until automatic switch-off; then the heating level
is displayed again and the operating light(7) is
permanently illuminated again.
ð The timer has been programmed and the device will
switch off after the predefined time.
2. In order to delete the setting, select 00 hours using the
Timer button(8).
ð The operating light(7) flashes.
ð The segment display(10) briefly indicates00 hours;
then the heating level is displayed again and the
operating light(7) is permanently illuminated again.
ð The timer has been deleted.
Procedure for IR2570S
ü The device is switched on.
1. Press the Timer button(8) several times to set the desired
number of hours until automatic switch-off.
ð The timer LED(17) is illuminated.
ð The segment display(10) indicates the number of hours
until automatic switch-off.
ð The timer has been programmed and the device will
switch off after the predefined time.
2. In order to delete the setting, select 00 hours using the
Timer button(8).
ð The timer has been deleted.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
Switch the device off.
Allow the device to cool down completely.
Hold onto the mains plug while pulling the power cable out
of the mains socket.
Clean the device according to the Maintenance chapter.
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation Article number
telescopic tripod 1.410.003.190
Errors and faults
Warning of electrical voltage
Tasks which require the housing to be opened
must only be carried out by authorised specialist
companies or by Trotec.
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
Check the power connection.
Check the power cable and mains plug for damages.
Check the on-site fusing.
Wait for 10minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device does not emit heat:
The heating rod might be defective. Have a defective
heating rod replaced by a specialist electrical company.
Check the heating level indication in the segment
display(10). If P.0 is displayed, the device is running in
standby mode.
Switch the device on by selecting another heating level
between P.1 and P.3.
RCD or another fuse trips:
Check the fuse. Switch off any other devices to reduce the
load on the line.
Contact a specialist electrical company.
The device slightly vibrates during switch-on and then
stops vibrating:
Slight vibrations during switch-on are a normal process.
No measures are required.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec IR2570S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec IR2570S in the language / languages: English as an attachment in your email.

The manual is 1,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec IR2570S

Trotec IR2570S User Manual - German - 13 pages

Trotec IR2570S User Manual - French - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info