737490
39
Zoom out
Zoom in
Previous page
1/43
Next page
- 36 -
Low battery signal
When the battery runs low (under 11 V) a conti-
nuous signal tone sounds to indicate that the bat-
tery needs to be charged. The operation
LED/Overload indicator
t
continues to light up
green.
When the battery voltage drops below 10 V
the power inverter switches off and the operation
LED/Overload indicator
t
lights up red.
Charging the USB device
Attention!
Before connecting, check to ensure that the
power consumption of the USB device is not
higher than 500 mA. Further information is to
be found in the operating manual for your
USB device.
Plug the USB connector of the USB device to the
USB port
y
of the voltage converter.
If necessary, switch the USB device on.
Note:
The 220-240 V power socket
r
and the USB
connector
y
can be used simultaneously.
Exchanging the Cable Fuse
Risk of potentially fatal electrical
shock:
Disconnect the power inverter from the power
source before changing the fuse. Also remove
any devices connected to the power inverter.
Replace the fuse with an equivalent type in regard
to the specified technical data and with the same
shut-off characteristics.
Before switching on and resuming operations with
the voltage converter, establish the cause for the
triggering of the fuse.
To exchange the fuse, proceed as follows:
Loosen the screw on the fuse holder
u
using a
Phillips screwdriver.
Open the cover of the fuse holder
u
and pull
the flat car fuse from the holder.
Install a new 20 A flat car-type fuse (supplied)
into the two connectors and replace the cover
onto the fuse holder
u
.
Firmly screw the screw on the fuse holder
u
back in.
GB
IB_79839_TSW150A1_GB_LB_BE.qxd 21.11.2012 15:42 Uhr Seite 36
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tronic TSW 150 A1 IAN 79839 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tronic TSW 150 A1 IAN 79839 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info