485071
302
Zoom out
Zoom in
Previous page
1/354
Next page
10-8
Troubleshooting > Solving Malfunctions
Solving Malfunctions
The table below provides general guidelines for problem solving.
If a problem occurs with your machine, look into the checkpoints and perform procedures indicated on the following
pages. If the problem persists, contact your Service Representative.
Symptom Checkpoints Corrective Actions Reference
Page
An application does not start. Is the Auto Panel Reset time short? Set the Auto Panel Reset time to
30 seconds or more.
9-23
The touch panel does not
respond when the main
power switch is turned on.
Is the machine plugged in? Plug the power cord into an AC outlet. 2-11
Pressing the Start key does
not produce copies.
Is there a message on the touch
panel?
Determine the appropriate response to
the message and respond accordingly.
10-13
Is the machine in Sleep mode? Press the Power key to recover the
machine from Sleep mode. The
machine will be ready to copy within
20 seconds.
2-21
Cannot print. Is the machine plugged in? Plug the power cord into an AC outlet. 2-11
Is the machine powered on? Turn on the main power switch. 2-13
Are the printer cable and network
cable connected?
Connect the correct printer cable and
network cable securely.
2-10
Was the machine powered on before
the printer cable was connected?
Power on the machine after
connecting the printer cable.
2-10
Is the print job paused? Resume printing. 8-3
Blank sheets are ejected. Are the originals loaded correctly? When placing originals on the platen,
place them face-down and align them
with the original size indicator plates.
3-10
When placing originals in the
document processor, place them face-
up.
3-12
Check that the application software is
correctly operated.
Paper often jams. Is the paper loaded correctly? Load the paper correctly. 3-2
Is the paper of the supported type? Is it
in good condition?
Remove the paper, turn it over, and
reload it.
3-2
Is the paper curled, folded or wrinkled? Replace the paper with new paper. 3-2
Are there any loose scraps or jammed
paper in the machine?
Remove any jammed paper. 10-22
Printouts are wrinkled or
curled.
Is the paper damp? Replace the paper with new paper. 3-2
Documents are printed
improperly.
Are the application software settings at
the PC set properly?
Check that the Printing System Driver
and application software settings are
set properly.
Cannot print with USB
memory.
USB memory not recognized.
Is the USB host blocked? Select [Unblock] in the USB host
settings.
9-22
Check that the USB memory is
securely plugged into the machine.
302


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Triumph-Adler DCC 6626 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Triumph-Adler DCC 6626 in the language / languages: English as an attachment in your email.

The manual is 14,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info