401518
23
Zoom out
Zoom in
Previous page
1/43
Next page
23
If a short tapered cut on the sides and back is desired, follow the diagram below:
The four basic areas illustrated on the hair cutting guide are your "road map" to easy do-it-
yourself hair cutting.
MAINTENANCE
Your clippers were carefully examined to ensure that the blades were
oiled and aligned before leaving our factory.
Blades must be realigned if they have been removed for cleaning or
replacement.
To realign the blades, simply match the upper and bottom blades teeth
up, point for point.
(End of top blade teeth)
should be approximately
1.2mm back from bottom blade.
Compare your clipper blades
with the sketch)
If blade alignment is incorrect, add a few
drops of oil to the blades, turn clipper on for a
few moments, turn off and unplug. Loosen
screws slightly and adjust. Tighten screws
after blade is aligned.
Oil
To maintain your clipper in peak condition,
the blades should be oiled every few
haircuts.
Do not use hair oil, grease, oil mixed with
kerosene or any solvent. As the solvent will
evaporate and leave the thick oil which may
slow down the blades motion.
Adjustable lever
The lever is conveniently located near your thumb (if you're right-
handed) so it can easily be adjusted while the clipper is in your hand.
The lever adds versatility to your clipper by allowing you to gradually
change the closeness of your cut without an attachment comb.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Tristar tr 2547 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Tristar tr 2547 in the language / languages: Dutch as an attachment in your email.

The manual is 4,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info