648016
37
Zoom out
Zoom in
Previous page
1/148
Next page
38
ENGLISH
Problem solving
7 Problem solving
7.1 Drive problems
• The system will not switch on (no beep from the battery), the LCD display remains blank
First check the battery pack. It must be in place and the lock must be pushed in fully. Check all
connectors and disconnect and reconnect if necessary. Make sure that the controller is slid into its
docking all the way. If this does not help, contact your dealer.
• The motor is always in generative mode
There is probably something wrong with the switch for generative braking in the right hand brake
lever. If there is something wrong with the generative braking switch, try switching the system off
and on again. If this does not help, unplug the connector between brake lever and controller. This
should solve the problem, but generative braking will be disabled. Contact your dealer.
• After a repair or service, the motor is not as powerful as it was earlier
On a bike with a rear motor, have the rear axle nuts tightened to the correct torque (40 Nm).
On a bike with a front motor, have the front as well as the rear axle nuts tightened to the correct
torque (40 Nm).
• The system does assist, but irregularly
On a bike with a rear motor, have the rear axle nuts tightened to the correct torque (40 Nm).
On a bike with a front motor, have the front-as well as the rear axle nuts tightened to the correct
torque (40 Nm).
• System switches on as Battery is put into Docking Station
This happens sometimes due to static electricity. There is no problem with the system.
7.2. Charging problems
• The display does not show ‘full’ after a complete recharge
Please make sure you are following all charging instructions.
Let the battery cool down for several hours and try again. If the problem persists, fully discharge
(by riding) and recharge battery, if necessary have your dealer update it to the latest firmware.
• The charging light does not turn red after connecting the power cable to the power source
Check the power cable to the power supply. If defective, replace the cable immediately.
Warning: Replace a damaged power cable immediately to prevent an electric shock.
• The charging light turns green after only 10 minutes of charging
Please make sure the system is turned off before you connect the power supply to a power source
or before you remove the battery to charge it.
7.3 Display problems
• Occasionally, the display active for 1 second.
This is normal: this happens roughly every half hour as the system self-checks
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trek RIDE plus R320 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trek RIDE plus R320 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trek RIDE plus R320

Trek RIDE plus R320 User Manual - Dutch - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info