E.9
Install the Sensor Wiring and Handlebar Bracket
Before proceeding, check that the wire is of adequate length
to mount the bracket on the handlebar. The handlebars should
freely rotate without placing tension on the wire, which could
damage a wire that is too short.
4. Route the sensor wire up the back of the
fork blade and secure with the provided adhesive
strips. Wind the wire upward
around the front brake cable
housing until the wire is adja-
cent to the handlebar, leaving
slack to accommodate move-
ment between the fork and
brake (Fig. 16). Also allow slack
between the cable housing and
handlebar (Fig. 17).
5. Attach the bracket to
the handlebar, on either side of
the stem. Position the bracket
end with the Phillips head screw
nearest the rider (Fig. 17).
Your computer comes with a bar clamp
which ts both 25.4 and 26.0mm diameter (mountain or road) handle-
bars. If your handlebar has a 31.8mm diameter, purchase the special
clamp from your dealer.
Fig. 16
Fig. 17
