24
2.3 Dangers due to electrical power
DANGER
Mortal danger due to electrical power
Mortal danger exists when coming into contact with live wires or subassemblies! Observe the
following safety notices to avoid dangers due to electrical power:
If the connection lead is damaged, you will need to have a special connection lead installed
by an authorized electrician.
Do not operate this device if its power cable or plug is damaged, if it does not work properly
or if it is damaged or has been dropped. If the power cable is damaged, it will need to be
replaced by the manufacturer or his service agency or a similar qualified person, to avoid any
dangers.
Do not open the housing on the device under any circumstances. There is a danger of an
electrical shock if live connections are touched and the electrical or mechanical structure is
altered. In addition, functional faults on the device can also occur.
3 Commissioning
This chapter provides you with important safety notices during the initial commissioning of the
device. Observe the following notices to avoid dangers and damages:
3.1 Safety information
WARNING
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
Packaging materials may not be used for playing. There is a danger of suffocation.
3.2 Delivery scope and transport inspection
As a rule, the ice cube maker is delivered with the following components:
Ice cube maker
Ice shovel
Ice basket
Manual
PLEASE NOTE
Examine the package for its completeness and for any visible damages.
3.3 Unpacking
Unpack your device as follows:
Take out the device from the box and remove the interior and exterior packaging.
Clean the appliance thoroughly before the first use. (see chapter Cleaning and maintenance)
3.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials are
selected in accordance with environmentally compatible and recycling-related points of view and can
therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the quantities of
accumulated waste. Take any packaging materials that are no longer required to “Green Dot”
recycling collection points for disposal.