DISMANTLING INSTRUCTIONS
1. Check to ensure that the pasta machine is not connected to the mains.
2. Remove the locking washer (11) together with the pasta attachment. If necessary, use the ring spanner
for this purpose.
3. Carefully remove the dough transport coil (10). If after use, the back of the coil is full of sticky dough,
first dismantle the coil according to the following instructions. You can remove the coil by lightly tapping
the end of the shaft and then removing the same.
4. Pull the closing slide (3) fully out of the appliance by gently pushing the locking button located above
the closing slide.
5. Press the unlocking button (4) for the cover, located on the front side of the cover (5) on the mixing
container (8) downwards by pulling it gently forward and lift the cover.
6. The unlocking button (7) for removing the mixing container (8) is located on the hinging side of the
cover near the casing (1).
7. Press the unlocking button and remove the mixing container.
8. Pull the chrome-plated drive shaft of the stirring mechanism (6) outward and remove it from the mixing
container.
9. Now carefully clean all the components that come into contact with the dough, either by hand or in the
dishwasher (*please read the instructions on the first page).
INSTALLATION INSTRUCTIONS
1. First check to ensure that the pasta machine is not connected to the mains.
2. Place the stirring mechanism (6) in the mixing container (8) with the largest opening facing the front
of the mixing container.
3. Place the stirring mechanism (6) in such a manner that the openings in the shaft of the stirring
mechanism coincide with the openings in the container.
4. Insert the chrome-plated drive shafts with the groove in the topmost drive opening of the motor casing
(1).
5. Press the unlocking button (7) on the motor casing downwards and push the mixing container (8)
together with the stirring mechanism over the chrome-plated drive shaft into the motor casing. It may be
necessary to turn the stirring mechanism (6) to some extent, so that everything falls properly in place. Now
unscrew the unlocking button (7) and check whether the locking has taken place properly by carefully
pulling the mixing container.
6. Push the closing slide (3) in the groove of the casing (on/off switch (2)) fully into the mixing position.
This is the position in which the closing slide is pushed as far as possible into the casing.
7. Push the dough transport coil (10) into the extrusion chamber (9) until it is in the hexagonal opening of
the motor casing (1). By carefully rotating the dough transport coil, it will come to rest in the proper place,
so that it will not project outside the threaded part of the extrusion chamber.
8. Select the desired pasta-shaping attachment and place it in the extrusion chamber (9), so that the
three projections of the extrusion chamber fit into the three grooves of the pasta-shaping attachment.
9. Hold the pasta-shaping attachment in place with a finger and push the sealing washer (11) over the
screw of the extrusion chamber (9) with simultaneous rotation in the clockwise direction. Only tighten
the sealing washer by hand. For this, use the ring spanner, otherwise there is a risk of stripping the
thread of the screw.
10. Now place the cover (5) on the mixing container (8). The installation is now complete.
PREPARATION OF PASTA
At the end of these instructions, you will find a couple of recipes so that you can start immediately with the
correct preparation in your pasta machine. You can prepare most of the known standard recipes using
the pasta machine. However, it is recommended that you start with the recipes mentioned here, so that
you become familiar with the use of the equipment and acquire a feeling for the kind of dough that you
are processing.
Remember the following:
is too dry) or more flour is required (if it is too wet).
