798768

Traeger XL - BBQ150.01 Manual

10
Zoom out
Zoom in
Previous page
1/24
Next page
SECTION THREE: SUBSEQUENT START-UP
With the Door open, turn the Switch ON (--) and the Temperature/Dial to SMOKE. In
approximately 2 minutes you will notice whitish-gray smoke coming out of the Grill as the
Pellets ignite. After assuring the Pellets have ignited, close the Door and set the
Temperature/Dial to any cooking setting desired. The Grill should be allowed to pre-heat for
approximately 10 minutes with the Door closed before placing food in the Grill.
WARNING! If at any time, the Grill fails to light or the fire in the Firepot goes out while cooking
or smoking, when sufficient pellets are still in the Pellet Hopper, it is important to follow these
steps. Failure to do so may cause a hazardous “over-firing” of your grill due to an excess of
unburned pellets in the Firepot.
1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord. If the Grill is still hot,
allow it to thoroughly cool. Open the Door and remove all food, the Porcelain Grills, Grease
Drain Pan and the Heat Baffle.
2) WARNING! Remove all unburned pellets and ash from inside and around the Firepot.
(See instructions for proper handling and disposal of ash in Section Five)
3) Before replacing the Heat Baffle, Grease Drain Pan and the Porcelain Grills, plug the power
Cord into an appropriate, grounded electrical outlet and restart the Grill. Pellets should fall
into the Firepot and the Hot Rod should begin to heat (it will start to turn red). CAUTION! Do
not touch it.
4) If this procedure is successful, you will soon see flames come out of the Firepot. Then turn
the Switch OFF (o), and let the Grill cool down. Position the Heat Baffle, the Grease Drain
Pan and Porcelain Grill in their proper locations. With the Door open, turn the Switch ON (--)
and the Temperature/Dial to SMOKE. In approximately 2 minutes you will notice whitish-
gray smoke coming out of the Grill as the Pellets ignite. After assuring the Pellets have
ignited, close the Door and set the temperature/Dial to any cooking setting desired.
5) If this procedure is not successful, see Section Six: FREQUENTLY ASKED QUESTIONS
for troubleshooting tips or contact Traeger Technical Support (Section Seven) to help
diagnose the problem before proceeding to the MANUAL LIGHTING INSTRUCTIONS
below.
MANUAL LIGHTING INSTRUCTIONS:
If the Hot Rod only is not operating, the Grill can still be used to cook and smoke using the
MANUAL LIGHTING PROCEDURE below:
1) DANGER! Turn the Switch OFF (o) and disconnect the Power Cord. Allow the Grill to
thoroughly cool if it is still hot. From beneath the Pellet Hopper, disconnect the Hot Rod
(Purple / White wire pair as shown in the wiring diagram near the end of this manual). You
will need to remove the Hopper Bottom Panel to access the wiring. Once the Hot Rod is
disconnected, replace the Hopper Bottom Panel and plug the Power Cord back into an
appropriate, grounded electrical outlet.
2) Open the Pellet Hopper and fill with TRAEGER BBQ PELLETS.
WARNING! USE ONLY TRAEGER BRAND BBQ WOOD PELLETS, which are
specifically made to work in our Grills. NEVER use heating fuel pellets in the Grill
due to potential hazardous contaminants and additives that may be present.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger XL - BBQ150.01 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger XL - BBQ150.01 in the language / languages: English as an attachment in your email.

The manual is 1.37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info