798756

Traeger Renegade Pro - TFB38TOD Manual

21
Zoom out
Zoom in
Previous page
1/24
Next page
traegergrills.com
|
21
Question Answer
Why does my grill
re go out on
SMOKE setting?
There may be excess ash in the repot which needs to be cleaned.
WARNING! If the re in the repot
goes out while smoking and there
are sufcient pellets in the pellet
hopper, it is important to complete
the following instructions. Failure to
do so may cause a hazardous “over-
ring” of your grill due to an excess
of unburned pellets in the repot.
DANGER! Turn the switch OFF (O) and
disconnect the power cord. Allow the grill to cool
thoroughly. Open the door and remove all food,
the porcelain-coated grill grate, the grease drain
pan, and the heat shield.
WARNING! Remove all unburned pellets
and ash from inside and around the repot.
(See instructions for proper handling and
disposal of ash in on page 19.)
Before replacing the heat shield, grease drain
pan, and porcelain-coated grill grate, plug
the power cord into the appropriate grounded
electrical outlet and turn the switch ON (I).
Pellets should fall into the repot and the hot
rod should begin to heat (it will start to turn
red). CAUTION! Do not touch the hot rod.
When ames start to come out of the repot,
turn the switch OFF (O). Let the grill cool down.
Now you’re ready to place the heat shield, grease
drain pan, and porcelain-coated grill grate back
into the grill. With the door closed, turn the
switch ON (I) and turn the temperature dial to
SMOKE. In about 2 minutes, the pellets will
ignite and whitish-gray smoke will come out of
the grill. After the pellets have ignited, turn the
temperature dial to any cooking setting desired.
If this does not x the problem, contact
Traeger's VIP-365 Customer Service
(see page 26) for assistance.
With the Traeger
Digital Pro
Controller, what
dial setting is
recommended for
starting the grill?
The auto-start procedure is the same for all grill controls. With the door closed, turn
the switch ON (I) and turn the temperature dial to SMOKE. In about 2 minutes, the
pellets will ignite and whitish-gray smoke will come out of the grill. After the pellets
have ignited, turn the temperature dial to any cooking setting desired.
How do I protect
my paint nish?
Use the protective cover on the grill and touch-up paint to repair any scratches.
Touch-up paint is available from your Traeger dealer, or log onto our website,
traegergrills.com.
Every 90 days, use a high-quality car wax on the outside surfaces of the grill.
ONLY APPLY WAX TO A COLD GRILL.
Where can I get a
new part for my
grill?
Check with your Traeger dealer. They
may have the part in stock or can
order the part for you.
In either case, please provide your name, phone
number, address, model, and serial number of
the grill (located on the label inside the hopper
lid), along with the part identication number
from the component diagram or parts list.
Contact Traeger's VIP-365 Customer
Service (see page 26) to place an
order.
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger Renegade Pro - TFB38TOD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger Renegade Pro - TFB38TOD in the language / languages: English as an attachment in your email.

The manual is 8.29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info