Manual Toyotomi TAD-235E (page 10 of 88) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish)

727656

Zoom out

Zoom in

1/88

ENGLISH

2. OPERATION

OPERATING STEPS:

1. PRESS “POWER” BUTTON (C1) TO “ON”.

2. PRESS MODE BUTTON (C5).

Press the mode button (C5) to set your desired operation

mode “Cool” (C7), “Dehumidify” (C8), “Fan” (C9) or “Heat”

(C12) (For TAD-235E).

Cool mode (C7)

During the “Cool” mode the air is cooled and hot air is ex-

hausted from the exhaust outlet.

NOTE: During Cool mode, you can adjust set temperature and

FAN speed.

Dehumidify mode (C8)

Air is dehumidified as it passes through the unit, without being

in full cool mode.

NOTE: In “Dehumidify” mode operation, you cannot change

the fan speed.

Fan mode (C9)

The “Fan” mode provides only circulation of room air, so that

you cannot set the room temperature.

NOTE: All mode indicators on the unit will be OFF. Fan speed

can be adjusted.

Heat mode (C12) (For TAD-235E)

Under this mode, heating mode indicator is bright. Seven seg-

ment display shows set temperature. Temperature setting

range is 16°C~30°C.

3. PRESS TIMER / TEMPERATURE ADJUST BUTTONS (C6)

Press timer button (C4) to enter into timer setting mode. Under

this mode, press “+” or “−” button (C6) to adjust the timer set-

ting. Timer setting will increase or decrease 0.5 hour by press-

ing “+” or “−” button within 10 hours, while timer setting will

increase or decrease 1 hour by pressing “+” or “−” button be-

yond 10 hours.

After timer setting is finished, the unit will display temperature

if there’s no operation for 5 seconds. The status will be shown

on the digital indicator if timer function is started up. Under

timer mode, press timer button again to cancel timer mode.

4. PRESS FAN SPEED BUTTON (C3)

Press the fan speed button (C3) to set the desired air flow rate.

Under “Dehumidify” mode, this button is invaild.

Auto · · · · · · · · Operation at air flow automatically accord-

ing to ambient temperature

High · · · · · · · · Operation at a high air flow

Med · · · · · · · · Operation at a medium air flow

Low · · · · · · · · Operation at a low air flow

5. STOP OPERATION

Press the Power button (C1) and all lights will go out.

SLEEP MODE OPERATION (C2)

Press “Sleep” button (C2) to enter into sleep mode. When the unit

operates at Cooling mode, preset temperature will increase 1°C by

1 hour. After 2 hours, the unit will keep operation at this

temperature all the time.

(For TAD-235E) If the controller operates at heating mode, after

sleep mode is started up, preset temperature will decrease by 1°C

within 1 hour; preset temperature will decrease by 2°C within 2

hours and then the unit will operate at this temperature all the time.

NOTE: Sleep function is only for Cool mode and Heat mode (For

TAD-235E), and not available for Fan, Dehumidify, and Auto

mode.

HORIZONTAL ADJUSTABLE LOUVER (A2)

The air outlet can be adjusted upward or downward. (Fig. K1)

CAUTION:

Do not adjust the horizontal louvers to the lowest or the highest

position during the Cool or Dehumidify mode with the fan speed

set to Low for an extended period of time, condensation may form

on the louvers.

VERTICAL ADJUSTABLE LOUVER (A4)

The air outlet can be adjusted rightward or leftward. (Fig. K2)

CAUTION:

Do not adjust the vertical louvers to the extreme left or right during

the Cool or Dehudmifiy mode with the fan speed set to Low for an

extended period of time. Condensation may form on the louvers.

REMOTE CONTROL HOLDER (B8)

To prevent the remote control from being misplaced, place remote

control to the remote control holder on the unit when not in use.

3. USING REMOTE CONTROL

After putting through the power, the air conditioner will give out a

sound. After the operation indicator “

” is ON (red indicator), you

can operate the air conditioner by using remote control. By press-

ing the button on the remote control, the signal icon “

” on the

display of remote control will blink once and the air conditioner will

give out a sound, which means the signal has been sent to the air

conditioner.

The functions work the same as your air conditioner’s operation

panel. (Fig. C)

Set temperature and clock icon (For TAD-229E) will be displayed

on the display during the unit OFF.

If you set some function by remote control, the corresponding set

icons and light will be shown on the display.

NOTE:

• The interval between two motions cannot exceed 5 seconds,

otherwise the remote control will exit setting status.

TIMER / TEMPERATURE ADJUST BUTTON (C6)

Pressing adjust button (C6) once will increase or decrease set tem-

perature by 1°C(°F).

Holding adjust button (C6) for 2 seconds, the set temperature on

remote controller will change quickly.

NOTE:

• Under OFF status, pressing “—” (For TAD-220E, TAD-226E

and TAD-235E) or “▼” (For TAD-229E) button and “MODE”

button simultaneously, you can switch between °C and °F.

• Temperature cannot be adjusted under auto mode.

X-FAN BUTTON (Internal drying operation) (C11)

(For TAD-220E, TAD-226E and TAD-235E)

Press this button (C11) under Cool and Dehumidify mode to start

up X-fan function. Press this button again to cancel X-fan function.

When X-fan function is on, if the air conditioner is turned off, indoor

fan will keep operation at low speed for a while to blow the residual

water inside the air duct.

NOTE:

During X-fan operation, press X-fan button to turn off X-fan

function. Indoor fan will stop operation immediately.

(For TAD-229E)

Press the X-FAN button (C11) or hold fan speed button (C3) for 2

seconds in Cool or Dehumidify mode, the icon “

” is displayed

and the indoor fan will continue operation for a few minutes in order

to dry the indoor unit even though you have turned off the unit. After

energization, X-FAN OFF is defaulted. X-FAN is not available in Auto

or Fan mode. This function indicates that moisture on evaporator of

indoor unit will be blowed after the unit is stopped to avoid mould.

•

Having set X-FAN function on: After turning off the unit by press-

ing ON/OFF button indoor fan will continue running for a few min-

utes at low speed. In this period, hold fan speed button for 2 sec-

onds to stop indoor fan directly.

•

Having set X-FAN function off: After turning off the unit by press-

ing ON/OFF button, the complete unit will be off directly.

TIMER BUTTON (C4)

(For TAD-220E, TAD-226E and TAD-235E)

OFF TIMER

When unit is on, press “TIMER” button (C4) to set OFF timer.

2. The character of HOUR and OFF will be blinking.

3. Within 5 seconds, press + or - button to adjust the time for

OFF timer. Pressing + or - button once will increase or de-

crease the time by 0.5 hour. Holding + or – button for 2 sec-

onds, time will change quickly. Release the button after your

required set time is reached. Then press TIMER button to con-

firm it.

4. The character of HOUR and OFF will stop blinking.

ON TIMER

When unit is off, press this button to set ON timer. The following

procedure is same as the procedure for OFF TIMER. Refer the

above instruction for OFF timer.

(For TAD-229E)

OFF TIMER

Press TIMER OFF button to initiate the auto-off timer. To cancel the

auto-timer program, simply press the button again. TIMER OFF

setting is the same as TIMER ON.

ON TIMER

Press TIMER ON button to initiate the auto-ON timer. To cancel the

auto-timer program, simply press this button again.

After press of this button,

disappears and “ON” blinks. 00:00 is

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi TAD-235E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 30,61 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toyotomi TAD-235E Manual

Product: