650602
12
Zoom out
Zoom in
Previous page
1/16
Next page
REPLACING
WARNING: Before rep
1. FIRST CHECK THE
When the igniter co
replace the batterie
may be defective.
2. CHANGE THE IGNIT
Remove the batterie
Release the automa
as described in Item
Note that the ignite
flashlight bulb fits in
To remove the ignit
while holding the sid
Install the new ignite
Replace the heat ch
At the end of each h
period of time, the follo
1. DRAIN FUEL SUB TA
After you have burn
(paraffin) will remain
odor to avoid conta
date. To do this, d
throng 4 under “
acceptance fitting fr
Tilt the drip tray tow
(paraffin) with a siph
Replace the fuel acc
Replace the cabinet
2. REMOVE BATTERIE
3. STORE HEATER
The original shipping
you do not have ori
large plastic bag and
NOTE: The space between the wick adjuster and the primary air tube
should be even all around.
NOTE: Make certain the top of the wick adjuster and the top of primary
air tube are the same height. If they are uneven, the flames tend
to be uneven, too.
15. Tighten the four (4) wing nuts around the wick adjuster.
16. Operate the wick adjuster knob to be sure the wick moves
smoothly up and down.
AFTER REPLACING THE WICK, CHECK THE OPERATION OF THE
AUTOMATIC EXTINGUISHER.
Wick height on position 1 of wick life extender should be 10 mm,
when wick adjuster knob is fully clockwise. Be sure to check.
NOTE: Remember always start new wick on position 1 of wick life
extender.
NOTE: If wick does not move smoothly and easily, or wick height is
more or less 10 mm, do not use heater, disassemble and repeat
items 11 through 16.
NOTE: If any ragged edges appear on the top of the wick, trim them
with a scissors carefully. DO NOT cut the body of the wick.
Remove the wick adjuster knob from the wick adjuster shaft once
more.
17. Replace the cabinet and secure it into position with three (3)
screws.
Replace the wick adjuster knob on the wick adjuster shaft. Install
the heat chamber. Grasp the wire handle, them turn the heat
chamber left and right to insure that it is properly seated. Once
again check the proper operation of the automatic extinguisher.
NOTE: Before lighting a new wick for the first time, turn the wick to its
lowest position. Allow the wick to saturate with kerosene for
thirty (30) minutes.
18. Put the batteries into the battery holder.
Space
Top of
primary
air tube
Top of
wick
adjuster
Wick
Wick
adjuster Primary
air tube
*Wick height Wick
10 mm
11
RCA-2800 Type C_US 14.7.10 11:17 ページ 11
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi RCA-2800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi RCA-2800 in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info