650602
8
Zoom out
Zoom in
Previous page
1/16
Next page
Pull the wick adjus
completely from its s
The wick height adju
and 3, can be seen
Pull the control dial
from 1 to 2, or fro
the maximum wick
replace the wick adj
When suitable flame
position 3, it is
REPLACING THE
AUTOMATIC EXTING
NOTE: Never use po
adequate flame leng
EXTINGUISH
1. Turn the wick adju
requires about a qu
extinguished and th
NOTE: DO NOT use th
heater. Automa
heater is jarred
turn off the hea
2. Make sure the flame
3. Do not try to reli
extinguishing it off a
MANUAL SH
When quick shutoff is n
NOTE: For routine turn
the Automatic E
may cause un
adjuster knob s
Maximum
Correct
Minimum
Correct
Too low
Produces odor
GOOD
Too high
Produces smoke
and soot
BAD GOOD BAD
NOTE: An improperly seated heat chamber can cause high flame,
smoke, and potential damage to the heater itself. Do not leave
the heater until you have determined that the flame is burning
normally, will be described in the following section.
ADJUSTING THE FLAME
1. After lighting wait for the heat chamber to reach operating temperature. This will take several
minutes, then the flame will be visible.
2. CHECK THE FLAME HEIGHT
After five minutes, the entire heat chamber should be glowing red.
If necessary, raise or lower the wick by turning the wick adjuster knob to produce the proper flame
condition.
NOTE: Do not operate your heater wick set TOO LOW or TOO HIGH. Doing so will decrease
combustion efficiency and increase production of unwanted emissions. When operating
heater, be sure wick is high enough to keep the primary heat chamber heated to a uniform
red glow from its top to bottom.
3. ADJUSTMENT OF MAXIMUM WICK HEIGHT
After using the heater over a long period of time, you may observe that the flame length in heat
chamber does not reach its normal level in several minutes after lighting. When this condition is
observed, it means that the wick height needs adjusting the unique wick life extender.
To adjust the wick height using the wick life extender mechanism,
first release the automatic extinguisher by pushing the manual
shutoff button.
7
RCA-2800 Type C_US 14.7.10 11:17 ペー7
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi RCA-2800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi RCA-2800 in the language / languages: English as an attachment in your email.

The manual is 1,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info