Manual Toyotomi KS-27A (page 10 of 16) (English)

650610

Zoom out

Zoom in

1/16

ADJUSTING THE FLAME

1. After lighting, wait for the heat chamber to reach operating temperature. This will take ten (10) minutes,

after which the flame will be visible through the glass cylinder.

2. CHECK THE FLAME LENGTH

After (5) minutes, the entire heat chamber should be glowing red.

lf necessary, raise or lower the wick by turning the wick adjuster knob to produce the proper flame condition.

NOTE: Do not operate your heater with wick set TOO LOW or TOO HIGH. Doing so will decrease

combustion efficiency and increase production of unwanted emissions. When operating heater, be

sure wick is high enough to keep the primary heat chamber heated to a uniform red glow from top

to bottom.

NOTE: AIways observe the heater closely for the first 15-20 minutes after it is lighted to be sure it is

properly adjusted.

EXTINGUISHING THE FLAME

1. Turn the wick adjuster knob counterclockwise until it stops. Within a few

moments, the flame will be completely extinguished and the heater will be off.

2. Make sure the flame is out completely.

3. Do not try to relight the heater for at least three (3) minutes after turning it off,

as this may cause smoke and odor.

MANUAL SHUTOFF

When quick shutoff is necessary, push the manual shutoff down.

NOTE: For routine turn-off, DO NOT use the "Manual Shutoff" or activate the

”Automatic Extinguisher” by jarring the heater. These methods may

cause unwanted odor, soot and smoke. Only the wick adjuster knob

should be used for normal shutoff.

BAD

TOO LOW

Produces odor

GOOD

CORRECT

Most efficient

combustion

BAD

TOO HIGH

Produces smoke

and soot

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi KS-27A in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Toyotomi KS-27A Manual

Product: