728831
18
Zoom out
Zoom in
Previous page
1/24
Next page
SE
LO
At t
follo
1.
2.
3.
4. To
Take
17
The following symptoms are normal during operation of the heater.
BEFORE REQUESTING A SERVICE CALL
*lf rapid “chugging” sound from fuel pump does not cease and if heater shuts OFF…….
1. Push Fuel Sump Red Reset Button. (See Page 7.) DO NOT hold down.
2. Insure that all valves (including fire valve) are open.
3. Insure external fuel tank has fuel and fuel filters are clean.
SECTION G:
TROUBLESHOOTING
ERROR CODE
E-0
E-2
E-6
E-8
E-12
E-13
E-22
E-23
-- : --
Hi
Lo
INFORMATION
Power failure (low voltage, unstable frequency)
Ignition safety feature is activated. / No fuel
Extinguished during operation. / No fuel
Blower motor malfunction
Overheating safety feature is activated.
Burner thermistor malfunction
Excess fuel in the burner
Ignition failure three times
Primary flame rod (Flame sensor) is malfunction and/or dirty
Timer is not setting.
Room temperature is higher than 35˚C (95˚F).
Position of room temperature sensor is not correct.
Room temperature is lower than -10˚C (14˚F).
Room thermistor malfunction or disconnected.
WHAT TO DO
Check power source.
Contact your dealer. / Refill fuel.
Contact your dealer. / Refill fuel.
Contact your dealer.
Clean the air filter and remove dust.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Consult your dealer.
Set the timer.
Check the position of room temperature
sensor. / Contact your dealer.
Check the position of room temperature
sensor. / Contact your dealer.
When heater is started
or extinguished.
When heater is
in operation.
CONDITION
White smoke or smell inside home when the heater
is first used.
Flashing flames visible in viewing window for a few
minutes after ignition.
Irregular metallic “cracking” noises when heater is
ignited or extinguished.
Warm air is not discharged as soon as ignited.
Audible “chugging sound” from fuel pump.
Regular pulse “Ticking” noise from heater.
Heat chamber or heat exchanger can be seen
through the air outlet louver’s glowing red hot.
Occasional yellow flickering in blue flame.
REASON
Machine oil used in factory assembly, or transit
dust burns off the surfaces of the burner or heat
exchanger.
The burner is cold and igniter is kept running for a
while after.
Expansion / contraction of hot metal components
within the heater warming and cooling.
Delay is to prevent nuisance cool air.
Air is in the fuel pump (No fuel). At first “Start Up” the
rapid “chugging noise”, may continue for a minute or
two, until air is purged from the pump*.
Sound of fuel pump in normal operation.
Normal
Normal
FF_V30_Type B_4 language.qxd 15.7.1 9:19 ページ 17
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Toyotomi FF V30T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Toyotomi FF V30T in the language / languages: English as an attachment in your email.

The manual is 3,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info